Laserfiche WebLink
TANK ANNULAR TESTING <br />Test Method By: • Manufacturer O Industry Standard O Professional Engr. O Other (see below) <br />Test Method Uses: O Pressure • vacuum o Hydrostatic o Other (see below) <br />Measuring Equipment Used: Vacuum Gauge (range 0 to 30 inches Hg) <br />uescription <br />TanK 91 <br />Tank #2 <br />Tank #3 <br />Product stored <br />Gasoline - 87 <br />Gasloine - 91 <br />Diesel <br />Tank manufacturer <br />Trustco <br />Trusco <br />Trusco <br />Tank material <br />Steel <br />Steel <br />Steel <br />Tank capacity (US gallons) <br />12,000 <br />6,000 <br />6,000 <br />Is this a multi -compartment tank? <br />No <br />No <br />No <br />Dry or Brine filled annular? <br />Dry <br />Dry <br />Dry <br />Monitoring system show normal annular? <br />Yes <br />Yes <br />Yes <br />Is water table above tank bottom? <br />Unknown <br />Unknown <br />Unknown <br />Was sensor removed for testing? <br />Yes <br />Was sensor properly replaced after testing? <br />Yes <br />Wait time for vacuum to stabilize (hrmin) <br />:15 <br />Test start time <br />1:48 PM <br />Initial vacuum (inches Hg) <br />7.0 <br />Test end time <br />2:48 PM <br />Final vacuum (inches Hg) <br />_ 6.0 <br />Test duration (hr:min) <br />1:00 <br />Change in vacuum (inches Hg) <br />1.0 <br />Pass/Fail threshold (inches Hg / hour) <br />2.0 <br />TEST RESULT <br />PASS <br />Comments: <br />0 2012 Walton Engineering, Inc. <br />