WORK PLANS - Laserfiche WebLink

Home Browse Search

Field staff must review job-specific work plan and coordinate with project manager to verify that all up-front logistics are completed prior to starting work including, but not limited to, permitting, access agreements, and notification to required contacts (e.g. site managers, inspectors, clients, subcontractors, etc.). A tailgate safety meeting must be performed and documented at the beginning of each workday. Plan, Prevent, Execute(PPE)/Safe Performance Self Assessment(SPSA) procedures must be used throughout the project. Weather conditions (heat, cold, rain, lightning) must also be considered. Each employee is empowered, expected, and has the responsibility to stop the work performed by him/herself or another co-worker if the working conditions or behaviors are considered unsafe.All employees should actroactivel to identi and mitigate hazards to the safest extent of their ability- Store bili . Store purge water(if any) Steel toed and shank shoes, Back strain. Exposure to • Use proper equipment to transport water(pumps, drum dollies, onsite. hardhat, safety glasses with contaminants. If disposing etc). -STANTEC/Contractor. side shields, hearing protection, through onsite treatment • Have appropriate respirator with combination organic vapor P-100 reflective safety vest, and system, damage or injury cartridges within 3- 5 feet of working location, readily available- leather gloves for the non- from improper use of STANTEC/Contractor. chemical aspects of work as equipment. Improper • Label storage containers properly, and locate in isolated area away necessary. If you suspect that storage or disposal. from traffic and other site functions-STANTEC/Contractor. equipment is contaminated, wear chemical resistant gloves. • Coordinate offsite disposal (where applicable) -STANTEC. Wear appropriate air-purifying respirator with combination • Do not attempt to lift, push or move drums without the proper tools organic vapor 1 P-100 or equipment-STANTEC/Contractor. , : cartridges as needed.Wear appropriate chemical resistant • Store purge water in 55-gallon drums. Drums will be staged in a suit as needed. location determined by the SHSO and the Property Owner/Station Manager-STANTEC. x + Drums containing flammable/combustible liquids or solids must be grounded and if there are multiple drums bonded together- STANTEC. ' • Use extreme care when opening the bung caps. Stand an arms length away and open the bung slowly to relieve any built up pressure-STANTEC/Contractor. . Supervisor/SHSO must Steel toed and shank shoes, Possible injuries and •Visually inspect each and every boreholetmonitoring well- confirm all hardhat, safety glasses with damage to property due to STANTEC/Contractor. boreholes/monitoring wells side shields, hearing protection, stepping into or driving are closed, filled in and/or reflective safety vest, and over the well. capped. leather gloves for the non- chemical aspects of.work as necessary. - Perform personnel dry, Chemical exposure. • Perform dry boot wash using a stiff bristle, fiberglass handled decontamination brush paying special attention to the welt and sole areas of the boot. procedures. Put street shoes on. Wash hands, face arms and neck (any exposed skin) (use baby wipes if a washing facility is unavailable) Decontamination water will be stored in 55 gallon drums-STANTEC STANTEC Consulting Corporation. 13-18