WORK PLANS - Laserfiche WebLink

Home Browse Search

Field staff must review job-specific work plan and coordinate with project manager to verify that all up-front logistics are completed prior to starting work including, but not limited to, permitting, access agreements, and notification to required contacts(e.g. site managers, inspectors, clients, subcontractors, etc.). A tailgate safety meeting must be performed and documented at the beginning of each workday. Plan, Prevent, Execute(PPE)/Safe Performance Self Assessment (SPSA) procedures must be used throughout the project. Weather conditions (heat, cold, rain, lightning) must also be considered. Each employee is empowered, expected, and has the responsibility to stop the work performed by him/herself or another co-worker if the working conditions or behaviors are considered unsafe.All employees should act eroactively to identify and miti ate hazards to the safest extent of their abilit . MMStore purge water(if any} Steel toed and shank shoes, Back strain. Exposure to • Use proper equipment to transport water(pumps, drum dollies, onsite. long sleeve shirt, hardhat, contaminants. If disposing etc.). safety glasses with side through onsite treatment • Perform air monitoring as outlined in Section 11 - shields, hearing protection, system, damage or injury Stantec. reflective safety vest, and from improper use of • Have appropriate respirator with combination organic vapor/P-100 chemical resistant gloves as equipment. Improper cartridges within 3-5 feet of working location for quick access- necessary. Wear appropriate storage or disposal. Stantec/Contractor. air purifying respirator with • Label storage containers properly, and locate in isolated area away combination organic vapor/P- from traffic and other site functions- 100 cartridges as needed. Stantec/Contractor. • Coordinate offsite disposal (where applicable)- Stantec • Do not attempt to lift, push or move drums without the proper tools orequipment-Stantec/Contractor. Perform personnel dry Chemical exposure. • Perform dry boot wash using a stiff bristle, fiberglass handled decontamination brush paying special attention to the welt and sole areas of the boot. procedures. Wash hands, face arms and neck(any exposed skin) (use baby wipes if a washing facility is unavailable) Decontamination water will be stored in 55 gallon drums-Stantec. • Drums will be staged in a location determined by the SHSO and the Property OwngrlStation_Manager- Stantec. • Drums containing flammable/combustible liquids or solids must be grounded-and-if there-are-multiple-drums-bonded-together= 4W Stantec. • Use extreme care when opening the bung caps. Stand an arms length away and open the bung slowly to relieve any built up pressure-Stantec. Supervisor/SHSO must Possible injuries and • Visually inspect each and every borehole- confirm all boreholes are damage to property due to Stantec. closed, filled in and/or stepping into or driving capped over the well. STANTEC Consulting Corporation x 13-25