Laserfiche WebLink
San Joaquin County <br />Environmental Health Department <br />600 East Main Street <br />Stockton, California 95202-3029 <br />rWebsite: www.sjgov.org/ehd <br />Phone: (209) 468-3420 <br />Fax: (209) 464-0138 <br />February 11, 2009 <br />Carl W. Henderson <br />HMC — Henderson Maint Co. <br />P.O. Box 31325 <br />Stockton, CA 95213 <br />DIRECTOR <br />Donna Heran, REHS <br />ASSISTANT DIRECTOR <br />Laurie Cotulla, REHS <br />PROGRAM COORDINATORS <br />Carl Borgman, REHS <br />Mike Huggins, REHS, RDI <br />Margaret Lagorio, REHS <br />Robert McClellon, REHS <br />Jeff Carruesco, REHS, RDI <br />Kasey Foley, REHS <br />Sent via Fax : (209) 465-4988 <br />RE: Arco Station #82695, 130 S. Wilson, Stockton CA 95205 (SR0056484) <br />The San Joaquin County Environmental Health Department (EHD) has completed the <br />review of the application for permit to replace the defective CTP controller from Master <br />STP, relocate and replace Veeder-Root PLLD from the Slave STP to the Master Slave, <br />and install Veeder Root Swiflcheck part #848480-003. The work was performed on <br />February 6, 2009 in an emergency repair. The PLLD was tested without the presence of <br />EHD inspector. The permit has been approved with the following conditions: <br />1. Contact the local fire department and the San Joaquin Valley Air Pollution <br />Control District for any applicable permits and requirements. <br />2. Qualified service technicians must possess or work under the direct and personal <br />supervision of an individual physically present at the work site who possesses all <br />of the following: <br />a. One of several permissible valid, current contractor's licenses issued by <br />the Contractors State License Board (may be issued to the installation <br />company), and <br />b. A valid, current California UST Service Technician certificate issued by <br />the International Code Council (ICC), and <br />c. A valid, current certificate of training from the manufacturer(s) of the <br />component(s) being tested, repaired, or serviced, and <br />d. Each person installing or testing any component must hold a certificate of <br />training from the manufacturer of that component. <br />3. Permit expires 180 days from date of approval. Note: If an extension to the <br />expiration date is required, a written request must be submitted to this office prior <br />to the expiration date. <br />Page 1 of 2 <br />