Laserfiche WebLink
10 <br />INSTALLATION, CONT’D.: FRONT PANEL BRACKET ATTACHMENT TO FRONT PANEL & CASE <br />10. Front Panel Attachment Instructions, Cont’d <br /> <br />Assembly Note: Case ships without front <br />panel / wood cladding on exterior and is not <br />included with the NSF Certification. <br />Panel brackets with holes (for screws) are <br />provided to attach wood cladding. <br />Illustrations show BACK SIDE of front panel <br />being attached to front panel support bracket. <br />Place screws into the wood cladding at the four <br />(4) vertical or horizontal obrounds at each of the <br />four (4) corners of front panel support bracket. <br />Place the newly assembled front panel onto the <br />four (4) retaining hooks. <br />Check that the top edge of the front panel wood <br />piece is FLUSH with the top surface of front <br />ledge (as shown in illustration below). <br />Remove and adjust accordingly. <br />Important! Front panel must be easily <br />removable from case (by lifting up and off <br />retaining hooks). Easy removal is for access <br />to both refrigeration package and base. <br />When proper fit is attained, place screws in the <br />eight (8) LOCKING SCREW HOLES (as shown <br />in illustration below). <br />1.68” <br />40.15” <br />18.63” <br />↑ UP .75” Each Side <br /> <br />Horizontal <br />Obround <br />(Typical) <br />Vertical Obround <br />(Typical) Locking Screw <br />Hole (Typical) <br />Slot for Front Panel Hook <br />(One at Each End) <br />Top Surface of Front <br />Ledge (Shown Here) <br />To Be Flush With <br />Top of Front Panel <br />Retaining Hook <br />(For Front <br />Panel). One at <br />Each End. <br />--- Front Panel (Back Side) --- <br />Top of Front Panel (Here) to Be <br />Flush With Top Surface of Front <br />Ledge (See Location Above) <br />Front <br />Panel <br />Support <br />Bracket