Laserfiche WebLink
9 <br />INSTALLATION, CONT’D.: FRONT PANEL BRACKET REMOVAL & ATTACHMENT TO FRONT PANEL <br />9. Front Panel Bracket Removal <br /> <br />Assembly Note: Front panel bracket is to be <br />removed and attached to front panel [or wood <br />cladding] as part of setup. <br />Brackets with holes (for screws) are provided at <br />specific locations to attach front panel (or wood <br />cladding). <br />Illustration and photo (below) shows various <br />locations of brackets to which attach. <br />Front panel support bracket is removable WITHOUT <br />screw removal. Simply remove by lifting up and off <br />Removable Front Panel Support Bracket <br />Shown Being Removed From Case <br />(Wood Cladding To Be Attached to Bracket <br />and Then Replaced). <br />Note: No screws required for removal! <br />See next page for attachment instructions. <br />Depending Upon Wood Cladding Design, <br />These Lower Side Brackets May Be <br />Unscrewed and Removed (To Attach <br />Wood Cladding Pieces). Both Sides. <br /> <br />hooks. See photo below. <br />Screws hold lower side brackets in place. <br />Depending Upon Front Panel (or Wood Cladding) <br />Design, Lower Side Brackets May Be Unscrewed and <br />Removed (To Attach Front Panel or Wood Cladding <br />Pieces). Both Sides. <br />See illustrations below. <br />See cover sheet of manual for sample illustrations of <br />BOTH cladded and un-cladded cases. <br />See more specific front panel attachment <br />instructions on next page. <br />View of Front Panel Support <br />Bracket Attached to Front Panel