Laserfiche WebLink
Site Address: SS#6313, 1 100 S MAIN STREET, MANTECA Date of Testing/Servicing: <br /> D. Results of Testing/Servicing <br /> Software Version Installed: / GI <br /> Com tete the following, checklist: <br /> Yes ❑ No* Is the audible alarm operational? <br /> Yes ❑ No* Is the visual alarm operational? <br /> 'es ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? <br /> es ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> El Yes ❑ N * If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> 1/A operational? <br /> es ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to operate-jar is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) Sump/Trench Sensors; B uispenserC5o .airunent Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? Q Yes; ❑No. <br /> ❑ Yes ❑ For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fillpoint(s)and operating properly? if so, at what percent of tank capacity does the alarm trigger? ????% <br /> ❑ Yes* 9No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement arts in Section E,below. <br /> ❑ Yes* No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br /> Product; ❑ Water. If yes, describe causes in Section E, below. <br /> ff <br /> s ❑ No* Was monitoring system set-up reviewed to ensure proper settings? <br /> Yes ❑ No* 1 is all monitoring equipment operational per manufacturer's specifications? <br /> * In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Page 2 of 3 03/01 <br />