COMPLIANCE INFO 2008 - 2011 - Laserfiche WebLink

Home Browse Search

CONTACT ` AOR MORE INFORMATION! ¢rn 5555 Skylone Blvd., SL A / Santa Rosa, CA 95403 �r Ph: (800) 688-3375 / Fx: (800) 700-1188 www.westernfg.com MEASURING PIPE RUNS: Co -Flex piping is available in 250', 500' or 1000' lengths. It may be ordered by the foot if required. Do not drag Co -Flex along the ground, step on or place heavy objects on top of the pipe. Cold weather will affect the flexibility. Leaving the pipe coils in the sun prior to installation will make them more pliable and easier to handle. In extreme cold weather, store the piping indoors, at room temperature before measuring and cutting. A personal type hair dryer can be inserted into one end of the pipe coil to warm up and relax the pipe. Cut and discard the first 12" (300mm) of pipe where any heating device has been attached. This section may be damaged by heat exposure. The Co -Flex termination fittings are 5" in length. 2" of pipe is inserted within the termination. An additional 3" is added to the total pipe length at each end of each pipe run by the installation of the terminations. For example, if the required pipe length between the internal or "T" connections inside two separated dispenser boxes is a total of 32' 9", you must subtract 6" to account for the terminations at each end of the pipe length. This pipe length will now be 32' 3" before termination. When measuring pipe lengths, use a pre -stretched line or flat tape to calculate the distance between connection points. Be certain to account for all sweeps and additional pipe lengths required within containment sumps for all connections before cutting. Co -Flex piping may be installed "lazy" within the piping trench. It does not have to be stretched straight or tight and can be routed to accommodate any pipe run requirements. It is important to maintain proper fall or slope. Piping lengths can be cut and terminated outside of the piping trench for ease of installation. Piping lengths may be pre-cut and terminated off-site. CUTTING AND TERMINATION: Co -Flex piping may be cut with any clean, sharp instrument. Be certain to make all cuts square and even. 1). Cut Co -Flex pipe to proper lengths.