Laserfiche WebLink
CONTACT I'- 'OR MORE INFORMATION! <br />5555 Skylane Blvd., SL A / Santa Rosa, CA 95403 <br />Ph: (800) 688-3375 / Fx: (800) 700-1188 <br />www.westernfg.com <br />11). Insert pipe onto termination and inside swage sleeve. Must be in at <br />least 1 1/2" or until just visible through holes in swage sleeve. <br />12). Hand pump or push button to draw swage mandrel through pipe <br />termination. <br />13). Release pump pressure and remove fitting. <br />14). When installing swage fittings, hand -tighten the coupling onto the <br />Western Fiberglass fitting until snug. Using a Co -Flex wrench, tighten the <br />coupling nut 1/4 turn more or to 200 in/lbs. without allowing the pipe to <br />rotate while tightening. <br />CAUTION: Do not over tighten. This may result in damage to the coupling <br />or potential leaks in the system! <br />CAUTION: Do not allow sealant to contact the threads of the swage fitting! <br />15). Remove the protective cap from the coax pipe coupling and verify <br />that the o -ring seals are clean and properly seated in their o -ring grooves. <br />Remove the plastic protective cap from the coax adapter, fitting or <br />connector and inspect the inside sealing surface to make sure it is smooth, <br />undamaged and free of dirt. Position the coax coupling to the male <br />threaded port of the coax fitting. This connection seals by way of static o - <br />ring seals and does not require pipe sealant. Thread the coax swivel nut <br />onto the male threaded port by hand, until the coupling bottoms out onto <br />the fitting and stop. DO NOT TIGHTEN THE NUT. <br />CAUTION: Do not use sealant inside coax couplings or on the connection <br />threads. This may result in a gasket failure! <br />PLEASE NOTE: Use only Dow Corning 55 O -Ring Lubricant or equivalent <br />when cleaning or replacing coax o -rings. <br />16). The 3/4" and 1" Co -Flex pipe couplings are fixed male NPT fittings and <br />are assembled as rigid steel pipe. After installing the appropriate test <br />boot, apply a liberal amount of thread sealant or Teflon tape to the <br />threads of the coupling and tighten to 20 ft/lbs. <br />17). The jacket of double wall Co -Flex piping must be tested to ensure <br />liquid tightness. Connect all test and connector tubes into the test boot or <br />coax fittings. Tighten all band clamps to 30 in/lbs. For coax fittings, use only <br />Page 10 of 38 <br />