Laserfiche WebLink
CONTACT I" 'OR MORE INFORMATION! <br />5555 Skylane Blvd., SL A / Santa Rosa, CA 95403 <br />atern <br />rglass Ph: (800) 688-3375 / Fx: (800) 700-1188 <br />www.westemfg.com <br />Dispenser Mounting Assembly (DMA) <br />INSTALLATION INSTRUCTIONS <br />Please read this manual completely prior to installation. These instructions <br />do not supersede local laws and regulations. Always comply with local <br />requirements. <br />The DMA is a simple design that incorporates either a fiberglass or a poly - <br />composite leak containment sump, U.L. Listed independent dispenser <br />base anchor and safety valve mounting systems into one complete unit. <br />The DMA is supplied with a containment sump unit, pre-installed mounting <br />assemblies for emergency valves, and concrete mounting anchors for <br />each dispenser anchor bolt. (According to dispenser model #) <br />OPTIONS: <br />Additional options are the Splashguard rain and wash -down water shield, <br />Installation Doors and the Retro -Fit Bracket System. Custom mounting <br />plates or other devices available. <br />DISPENSER BASE ANCHORS: <br />The dispenser mount anchor is a 2" x 1/2" threaded coupling with two 1" x <br />1/2" bolts, and one 1" x 3" x 100 ml steel concrete anchor bar. This anchor <br />assembly is mounted in the dispenser base mount position(s), based on <br />dispenser make and model # on the flange of the DMA before pouring <br />concrete. If not pre-installed from factory, install the 1 " x1/2' bolt and 1" x <br />3" anchor bar into one end of the coupling. Put the other 1" x 1/2" bolt <br />into the other end of the DMA box at the correct dispenser mount <br />positions. When concrete is poured, this assembly will be anchored into <br />the concrete. After the concrete has cured, remove the 1" x 1/2' bolts <br />from the top of the DMA flange and use them to mount the dispenser. <br />The Retro -Fit dispenser base anchors are 4" X 1/2" "J" bolts placed in the <br />Page 22 of 38 <br />