ARCHIVED REPORTS XR0007814 - Laserfiche WebLink

Home Browse Search

I and short bands if both lengths are provided)with the studs and angle ends sticking out away from the tank Fasten the bands together with the 3/811- 16 x 40 hex head bolts as shown in the drawing Raise the bands 17'and loosely Install the anchor clips using the 1/211- 13 hex nuts and 112" washers provided Tighten the 318"- 16 x 4" hex head bolts to remove band looseness Mark the slot locations of the anchor clips, remove the clips, and install the required number of 1/2"anchor bolts Anchor bolts are not provided by the manufacturer and must be purchased by the customer 3/8' FLAT MASMU 3ie LACK WASHER -16 X 4' E(JOA-N-C B'-i6 HEX NUT1/2' EX N MASHEi!AND HFJf NlliANOM CLIP 1/Y ANO�t BELT FIAT ..M LLOt YA98 AW 1r2' ANDUR B1bT ASST HEX aff[WSTp 37PPL]®� (1 RMI R�PER ANDUR CLIP CLIPI) CUSTEMFR SUPPLIER ANK 121A '-1 4' B0. (TN NU S IN 4B IN CLIPS HEX MASH9iST ANn ApTT WASHE S 4 B 4 4 1A 7 16 5 9 IB Figure 5 1 513 Replace the anchor clips and secure the clips to both bands and the concrete pad Do not over tighten the bands to the tank The band tension should only remove looseness and not cause any tank deflection 52 WIND/SEISMIC TANK RESTRAINT SYSTEM(FLAT BOTTOM TANKS) 5 2 1 The wind/seismic tank restraint system Is designed for tank restraint on an appropriate concrete pad under 110 MPH wind or seismic zone 4 conditions Using the assembly drawing and table shown in Figure 5 2, verify that all parts are present 522 Locate the tank on the concrete pad as desired Layout all anchors required (4 or 8)equally spaced, (4 anchors must be directly below the tank tie down locations) Make sure all anchors are located next to the tank with the 2 ea eye bait holes of the anchor on top of the weldment and the plate face of the anchor weldment located next to the tank. Mark all the anchor bolt locations, remove the anchors and install the required Hilb adhesive model HVA anchor bolts as specified by the assembly drawing and the SII seismic restraint drawings B-2686A through B-2688A These anchor bolts are not provided by the manufacturer and must be purchased by the customer. 623 Replace the anchors and secure the anchors to the concrete Install the 314"eyebolts loosely as shown by the drawing Fasten the tank to the concrete pad with the required cable (make sure the cable sheath is on the cable and located around the lug locations)as shown by the assembly drawing utilizing the cable thimbles and clamps provided Tension the cable before filling the tank to remove cable looseness Do not over-tension the cables as this may cause tank damage The cable tension will change with tank loading and temperature changes•DO NOT re-tension the cables 18