ARCHIVED REPORTS XR0007814 - Laserfiche WebLink

Home Browse Search

• sensor cord Into position Remove the indicator box cover Attach the indicator box to the PE mounting plates provided on the tank with the 2 ea 010 S S self-tapping screws Attach the sensor cable to the control box with small strain relief and connect wires per label in the box Connect unit to 110 VAC per label in the box using strain relief provided or other acceptable methods and test the unit The indicator box will show a green light when power is on and the sensor is not detecting a liquid The light Is a push to test light allowing the operator to test for power outage or malfunction If the green light goes out there are two posibildies The green light does not come on when the button is pushed This would indicate a lack of power to the unit or the light bulb is burned out If the green light comes on when pushed, then a possible leak condition is indicated 410 FLANGE ADAPTERS 4101 Standard flange adapters are constructed from PVC or CPVC and may be purchased for solvent weld socket fittings or threaded fittings Flange adapters for threaded fittings are provided with loose male adapter to allow the customer to adjust adapter length and flange position to match the piping at the Installation Refer to Figure 410 for an Illustration of a flange adapter 4102 When installing the flange adapter in a solvent weld socket fitting,cut the flange adapter to desired length and solvent weld the flange adapter vnth the proper solvent cement in the desired position in a previously installed fitting If the flange adapter Is to be used In a threaded fitting,install the male adapter into the fitting with Teflon®pipe sealant, cut the flange adapter to the desired length,and solvent weld the flange adapter to the male adapter in the desired position with the proper solvent cement 150# PVC RANGE O O 7 I 1 I O O I i 0 MALE AWTER (FOR TKREACEE] FITTINGS) Figure 4 10 5. TANK ACCESSORIES 51 LATERAL RESTRAINT SYSTEM(FLAT BOTTOM TANKS) 51 1 The lateral restraint system is designed for tank position restraint on a concrete pad inside of an enclosed building It Is not designed for wind or seismic restraint capabilities. Using the assembly drawing and table shown in Figure 51,verify that all parts are present 512 Locate the tank on the concrete pad as desired The pact required for the restraint system must be 15-314" larger in diameter than the tank diameter for proper application of 112"adhesive anchor bolts 0 (assumes 6-3/9"edge distance required) Layout the bands around the tank(alternate long bands 17