ARCHIVED REPORTS XR0007814 - Laserfiche WebLink

Home Browse Search

F-1000 Page 10 5.0 HOW TO OPERATE THE F-1000 • Note The calibrated units of measure such as GPM,LPM,M31-1,GALLONS,LITERS, CUBIC METERS,ect,And the decimal point location are pre-programmed at the factory to standard flow ranges(see chart) Any unit of measure can be factory programmed PIease contact the factory for details • The meter is shipped from the tactory with 2 AAA batteries Installer) • When measuring continuous flow(i a 24 hours per day,7 days per week),do not operate the meter in the upper 25%of the calibrated flow range The paddle speed in these high flow ranges is fast Damage to the paddle may occur if the meter is allowed to run continuously at the high flow rate, especially with corrosive or abrasive fluids • Moder F-1000-RB The F-1000-RB is the basic rate meter The meter will display the rate of flow from 01 through 999999 in any engineering units Some standard units of measure are GPM,GPH,GPD,LPM,LPH,LPD,M3H, etc • Model F-1000-TB The F-1000-TB is the basic totalizer meter The meter will display the total flow amounts from 01 through 999999 m any engmeermg umts Some standard units of measure are GALLONS,LITERS,CUBIC METERS Pressing and holding the RESET button(located on the front panel)for at least 2 0 seconds resets the total to zero This feature can be disabled--see Fig 12 below • Model F-1000-RT The F-1000-RT is the rate and totalizer meter The meter will display the flow rate amounts and the total flow amounts from 01 through 999999 in any engineering units Some standard units of measure are GALLONS PER MINUTE, GALLONS PER HOUR,GALLONS PER DAY,LITERS PER MINUTE, LITERS PER HOUR,LITERS PER DAY,CUBIC METERS PER HOUR,CUBIC METERS PER DAY Pressing the RESET button(located on the front panel)toggles the display between flow rate and total flow Pressing and holding the RESET button for at least 2 0 seconds while the total flow value is displayed will reset the total to zero This feature can be disabled--see Fig 12 below F-1000-RB F-1000-TB F-1000-RT � r �Rpp teiawe T M w7Fx1�Y __ 4.1 Y ed ''Fz v1'T r.�. '"'"E — .— •.•� F-1000 Circuit Board Header pms Terminal blacks JUMPER CONFIGURATION (Tail membrane connector) (AC Cad sensor input) Jumper Not Jumper ©� Installed(open) Installed 0 i 2 ■ O Black were (Negative lead) - oTotal flow reset Total flow reset + ' to zero Enable to zero Disable (Factory default) 'Mounting holes(x2) Screw #4 x 5U Philip oval'A" Jumpers Red vote (Front Panel Totalizer Reset (Positive lead) EnablelD,sable) 13eftry sig two AAA(1 5 V each) Fig 12 6.0 FLOW RANGES The F-1000 is factory calibrated tot 2%of full scale rate reading When measuring total flow, accumulated error over time must be considered Accuracy is based on laboratory testing of nominal pipe dimensions Your actual accuracy will vary based on your actual pipe I D And other installation factors • Due to increased wear on the paddle and axle,continuous operation at the upper 25%of the flow range is not recommended.