INSTALL 2016 TANK TOP UPGRADE - Laserfiche WebLink

Home Browse Search

F,1"=C,E1VED OCT 2 7 2016 MENTAL HEALTH Setting Overfill Alarm Horn Delay Time 1. Loosen the four screws that secure the Overfill Alarm cover clamps to the case. Slide the clamps away from the retaining lip on the door. Open the door. 2. Locate the Horn Time Delay Relay (see Figure 3). 3. Adjust the time the horn remains On from 0 to 60 seconds by turning the knob on the relay to the desired setting. 4. Close the door and tighten the four cover screws. Testing the Overfill Alarm with the Acknowledgement Switch Turn On power to the Overfill Alarm and Acknowledgement Switch. Depress and hold in the TEST Button on the right side of the switch. The Overfill Alarm horn will sound immediately, and the Overfill Alarm's red light will start flashing. The horn will turn Off at the preset delay time you set above (0 -60 seconds). The red light will continue to flash until the TEST button is released. Setting the Overfill Alarm Horn's Volume Level 1. Locate the adjustment set screw (1/16" Hex wrench) on the exterior of the Overfill Alarm's hom cover (see Figure 1 on page 3). 2. Turn the adjustment screw counterclockwise to increase the dB level of the horn or clockwise to decrease its dB level. Testing the Overfill Alarm with the Console 1. With the Overfill Alarm and Acknowledgement Switch (if installed) connected to the console, consult the setup instructions for your console and perform the Output Relay setup procedure to recognize the Overfill Alarm. O 2. Tum power Off to the console and the Overfill Alarm. Put a jumper between the two Overfill Alarm relay connections in the console. OVERFILL ALARM W/O ACKNOWLEDGEMENT SWITCH 1. Reapply power. If the Overfill Alarm is wired properly, the alarm horn should sound immediately followed by the red alarm light flashing. O2. Tum Off power to the console and to the Overfill Alarm. Remove the jumper between the Output Relay connections. OOVERFILL ALARM WITH ACKNOWLEDGEMENT SWITCH 1. Stand by the Acknowledgement Switch and have someone reapply power to the console and Overfill Alarm. If the Overfill Alarm is wired properly, the alarm horn should sound immediately followed by the red alarm light flashing.