COMPLIANCE INFO 1998 - 2004 - Laserfiche WebLink

Home Browse Search

r' .J-- Scope r Scope of work for ACT's Field service piping crews on pipe replacement. Page 1 of 2 1. Pull all necessary permits from Environmental Health, Fire Department, Air Quality Control ,or the Building Department in the County or City. I&.. Apply and pay fees , this may take from 2 -30 days piror to start lb. Call for inspection of pressure test of new piping 2448 hours in advance. 2. Introduce and explain your operation and time frame to the owner or person in charge at the job site. 3. Shut off all electricity to the turbines and dispenser's and lockout. 4. Place delineators, safety cones and caution tape to make a safe working zone. S. Open manways to the tanks , test with Gas -O -Meter before entry. 6. Open dispenser covers, test with Gas -O -Meter before entry. 7. Insert fresh air blower into each dispenser sump or tank sump as needed. 8. Determine and make a layout drawing of the job site. 9. De -water tank sumps and dispenser sumps as required. Dispose of any liquid properly. This to be done by third party. 10. Remove all leak detectors from turbines and connect jumper hose from the turbine to the tank fill. 11. Purge existing fuel from product lines back into the tanks with nitrogen. 12. Close the ball valves at the turbines. 13, Disconnect product lines at the turbines and capture any remaining fuel. 14. Remove dispensers ( if necessary ) .This is to be done by others. 15. Pour a minimum of 5 gallons of soapy water into each secondary pipe run (start at the highest end). 16. Disconnect product lines at tee's and 90 degree Ells in dispenser sumps. 17. Disconnect risers at the union on each dispenser product if dispenser has not been removed. 18. Remove impact emergency valve from dispenser frame. 19. Remove any fuel or water in the dispenser sumps. 20. Attach pulling cone with trailing pull rope to each end of primary pipe. 21. Pull primary pipe out of secondary pipe. 22. Pour any remaining fuel out of the primary product line back through the fill of the tank. 23. Measure the old product line. 24. Cut new pipe to the desired length. 25. Install couplings on each end of new pipe. 26. Test new line to 60 psi prior to inserting into secondary piping. 27. Attach the pulling cone that has the pulling rope through the secondary pipe. 28. Pull the new product pipe into the secondary pipe. 29. Repeat procedure's 15 through 28 for the other products. 30. Connect the piping at the 90 degree EI `s in the dispenser sumps.. 31. Connect the piping at the furthermost tee and make connections back to the turbine. 32. Connect piping at the turbine. 33. Attach risers to the dispenser product lines. 34. Attach the impact emergency valves to dispenser frame. 35. Close all impact emergency valves. 36. Attach testing lines to impact emergency valve test port outlet. 37. Pressurize new piping to 60 psi (or that which is required by local code) with nitrogen . Allow pipe to stabilize under pressure for 15 minutes. Then hold the pressure for the amount of time required by local code.