SU0005292 - Laserfiche WebLink

Home Browse Search

Ms. Hayes t August 22, 2005 PA-0500509 Page4 f Exits to adjoining streets should be designed to reduce time to re-enter traffic from the project site More information can be found at: http://www.lgc.org, http://www.sustainable.doe.gov/, http://www.consumerenerayQenter.org/index.htm1, http.,//www.ciwmb.ca,gov/GreenBuilding/ • The applicant should implement measures to reduce the amount of vehicle traffic to and from the residential area(s) that further reduce air pollution in the valley. This could include providing an information center for residents to coordinate carpooling. Check out the"Spare the Air"section of our website www.valleyair.org • The project.should include as many clean alternative energy features as possible to promote energy self-sufficiency. Examples include.(but are not limited to): photovoltaic cells, solar thermal electricity systems, small wind turbines, etc. Rebate and incentive programs are offered for alternative energy equipment. More information can found at- http://www.dsireusa.org/, -http://rredc.nrel:gov/, http://www.energy.ca.4ov/renewables/ • Construction activity mitigation measures include: Install sandbags or other erosion control measures to prevent silt runoff to public roadways from sites with a slope greater than one percent - Require that all diesel engines be shut off when not in use on the premises to reduce emissions from idling. , Limit area subject to excavation, grading, and other construction activity at any one time - Limit the hours of operation of heavy duty equipment and/or the amount of equipment in use Replace.fossil-fueled equipment with electrically driven equivalents (provided they are not run via a portable generator set) Curtail construction during periods of high ambient pollutant concentrations; this may include ceasing of construction activity during the peak-hour of vehicular traffic on adjacent roadways, and "Spare the Air Days"declared by the District. - Implement activity management (e.g. rescheduling activities to reduce short-term impacts and implementing measures to reduce the amount of single occupancy vehicle employee traffic to and from the project area) - During the smog season (May through October), lengthen the construction period to minimize the number of vehicles and equipment operating at the same time. i Off road trucks should be equipped with on-road engines when possible. - Minimize obstruction of traffic on adjacent roadways. The applicant should use California Air Resources Board (CARB) certified alternative fueled engines in construction equipment where practicable. Alternative fueled equipment may be powered by Compressed Natural Gas (CNG), Propane (LPG), electric motors, or other CARB certified off-road technologies. To find engines certified by the California Air Resources Board, see their certification website htt ://www.arb.ca. ov/ms ro /offroad/cert/cert. h . For more information on alternative fuel engines, please call Mr. Chris Acree, Air Quality Specialist, at (559) 230-5829. • Construction equipment should have engines that meet the current off-road engine emission standard (as certified by the California Air Resources Board), or be repowered with an engine that meets this standard. Tier I and 'Tier II engines have significantly less NOx and PM emissions compared to uncontrolled engines. To find engines certified by the California Air Resources Board, see http://www.arb.ca.gov/msprog/offroad/Cert/cert.php. This site lists engines by type, then manufacturer. The "Executive Order" shows what Tier the engine is certified as. For more information on heavy-duty engines, please contact Mr. Kevin McCaffrey, Air Quality Specialist, at (559) 230-5831. I i