SU0011424 - Laserfiche WebLink

Home Browse Search

Title 24). (Development Title Section 9-1015.9) 3) Each parking stall shall be an unobstructed rectangle, minimum nine (9) feet wide and twenty (20)feet long. (Development Title Section 9-1015.5[b]) 4) All parking stalls and directional arrows must be delineated with paint. (Development Title Section 9-1015.5[d]) e. ACCESS AND CIRCULATION: The following requirements apply and shall be shown on the Site Plan: 1) Access driveways shall have a width of no less than twenty-five(25) feet for two-way aisles and sixteen (16) feet for one-way aisles, except that in no case shall driveways designated as fire department access be less than twenty (20) feet wide. (Development Title Section 9- 1015.5[h][11) f. LIGHTING: Lighting shall be provided and comply with the following: 1) If the parking area is to be used at night, parking lot and security lighting shall be installed. (Development Title Section 9-1015.5[g]) 2) Any lighting shall be designed to confine direct rays to the premises. No spillover beyond the property lines shall be permitted except onto public thoroughfares, provided, however, that such light shall not cause a hazard to motorists. (Development Title Section 9-1015.5[g][4]) g. LANDSCAPING: Landscaping shall be provided and comply with the following: 1) All areas not used for buildings, parking, driveways, walkways, or other permanent facilities shall be landscaped. (Development Title Section 9-1020.7[a]) (Existing landscaping satisfies this condition) h. SCREENING: Screening shall be provided and comply with the following: 1) All storage materials and related activities, including storage areas for trash, shall be screened so as not to be visible from adjacent properties and public rights-of-way. Screening shall be six (6)to seven (7)feet in height. Outside storage is not permitted in front yards, street side yards, or in front of main buildings. (Development Title Section 1022.4[d][2]) i. BUILDING CODE REQUIREMENTS: The following California Building Code (CBC) and San Joaquin County Ordinance requirements will be applicable to the proposed project. The following conditions shall be addressed prior to submittal of a building permit application to the Building Inspection Division: 1) A building permit application including plans will be required. According to state law, the plans must be prepared by a registered engineer or licensed architect and shall be submitted for review and approval. An engineer or architect will also be able to help you make decisions about construction options related to fire sprinklers, allowable areas, firewalls and any necessary upgrades based on the configuration of the building and your specific needs. 2) The required plans must be complete at the time of submittal for a building permit. Plans must address building design and construction, fire and life safety requirements, accessibility and show compliance with the current California codes and San Joaquin County ordinances. A complete set of plans must include fire sprinkler plans, truss calculations, energy calculations, plumbing, electrical and mechanical drawings as well as structural calculations. 3) Based on our records the existing building proposed for use as an almond pressing operation will be a change in occupancy. The building was previously constructed and permitted as an agricultural Group U building and not to be used for food processing (Group F-1). A change in occupancy will require a code analysis report and necessary plans prepared by an architect or PA-1300218 (TE, UP) Conditions of Approval 2