SU0004091 - Laserfiche WebLink

Home Browse Search

(3) Provide approved toilets for all employees(chemical toilets are acceptable). (4) Provide handwashing facilities on or near the approved toilets. (Development Title Section 9- 1415.3[i]) i. SETBACKS: No excavation shall take place within twenty-five(25)feet of any property line or right- of-way (nor within the allowed slopes adjacent to said twenty-five (25) foot setback), unless the elevation prior to excavation is more than that of the abutting property, in which case the elevation within said twenty-five(25)foot setback shall at no time be less than that of the abuttingproperty, at the property line. (Development Title Section 9-1415.3U]) j. SLOPES: The following provisions do not apply to temporary interior cut slopes(i.e.,working slopes that do not fall within any of the criteria listed below). Temporary interior cut slopes shall comply with the Cal OSHA Code of Regulations and/or the Federal OSHA Code of Regulations as applicable. (DevelopmentTitle Section 9-1415.3[k]) (1) Terrace Drainage. Drainage plans with calculations shall be submitted for approval to the Development Services Division for all terraces as part of the Reclamation Plan. Terraces for reclaimed final slopes shall be sloped back towards the fill and be designed such that runoff is directed to collection points where it can enter catch basins and be conveyed via the toe of slope. The spacing of collection points shall pipes or other acceptable conveyance to be no greaterthan 1,500 feet, and each reclaimed final slope face that has terracing shall have a minimum of one (1) down drain. The method of transporting the water along the flow line of the terrace to the down drain, so as to prevent erosion and possible slope failure,shall be approved by the Development Services Division. The method of drainage of terraces for temporary slopes at setback lines shall be submitted to the Development Services Division for approval. (2) Slope Stability Factors of Safety. When required by the Title to provide site-specific geologic and engineering slope stability analysis, the following minimum slope stability factors of safety shall apply A. A minimum factor of safety of 1.5 against static deep seated failure. B. A minimum factor of safety of 1.5 against static surficial failure. C. A minimum factor of safety of 1.1 against seismic failure; (3) Temporary Cut Slopes at Setback Lines. Temporary cut slopes (i.e., for limited periods of time, slopes that are in the process of extraction prior to being backfilled) at setback lines shall not exceed one (1) foot horizontal to one (1) foot vertical, except that temporary cut slopes at setback lines to a maximum of one half (1/2) foot horizontal to one (1) foot vertical may be maintained if site-specific geologic and engineering analysis demonstrate through a slope stability analysis that the proposed temporary cut slopeswillhHowever,have the event that stebare ility factor of safety as required in Section 9-1415.3(k)(4). existing structures on the adjacent property (or the immediate potential for structures on the projected ed on a slope a of one(1)to one(1he excavation 1l at no)from the property line me be rto the to the toe rof slopeine than a line project p (4) Final Slopes. Final cut and/or fill slopes shall not exceed two (2) feet horizontal to one (1) foot vertical,except as specified below: QX-00-1\Roorda San Joaquin County Page 7 Community Development