SU0006924 - Laserfiche WebLink

Home Browse Search

Driveway and aisle widths are shown on the submitted site plan as well as the circulation patterns for ingress and egress traffic. However, the circulation pattern must demonstrate that there is adequate maneuverability for the approved number of trucks and trailers. The maneuvering area for trucks and trailers and the storage area for trailers must be shown on a revised Site Plan. Parking Development Title Table 9-1015.3(b) requires 1 parking space per 1,000 square feet of building for the use type Truck Services-Parking. The total square footage of the buildings shown on the site plan is 7,141 square feet. This indicates the minimum required number of parking spaces for the proposed project is seven (7). (Development Title Section 9-1015.10) However, additional parking will be required based on the total number of employees. (Development Title Section 9-1015.9) As stated by the applicant, the truck parking operation will have up to one employee per truck. They currently have three office employees. Therefore, the required total number of parking spaces will be 18, of which one must be a van accessible space. The revised Site Plan must show the location of the required number of automobile parking spaces. The Site Plan does show the proposed parking stalls for six (6)trucks and twenty (20) trailers. However, the Site Plan does not show the parking for the existing nine (9) trucks and the existing fifteen (15) trailers. In order to adequately demonstrate that the parcel can accommodate the proposed number of truck parking stalls, the revised Site Plan must show the location of all existing and proposed truck parking stalls. The guidelines for parking stall dimensions for automobiles are a minimum of twenty (20) feet long by nine (9)feet wide. (Development Title Section 9-1015.5) The required dimensions for truck parking stalls are twenty-five (25) feet long by fifteen (15) feet wide. (Development Title Section 9-1015.6[c][11) The dimensions for both automobile and truck stalls must be shown on the revised Site Plan. All permanent parking lots including parking spaces, driveways and maneuvering areas for trucks and automobiles must be surfaced and permanently maintained with asphalt concrete or Portland cement concrete to provide a durable dust free surface (Development Title Table 9- 1015.5[e]). Parking areas designated for trailer storage may be surfaced with a minimum of four inches of aggregate base. Paved areas and aggregate base areas must be shown on the revised Site Plan. Screening Development Title Section 9-1022.4[e](1) states, "If an industrial project abuts a residential zone, an area shown on the General Plan for residential use, or an existing residential use, a solid masonry wall six (6) to eight (8) feet in height shall be erected along the abutting property line." A.P.N.s 179-160-36, 179-171-34 and 179-171-05 are zoned R-L (Low Density Residential). A solid masonry wall will be required on the north, east and south property lines adjacent to these three parcels. In addition, any trailer storage areas shall be screened from the public roadway. (Development Title Section 9-1022.4[e][2][A]) Lighting If the parking area is to be used at night, parking lot and security lighting must be installed. 2