WORK PLANS - Laserfiche WebLink

Home Browse Search

i (d) Date(s) laboratory analyses were performed; (e) Name(s) of individual(s) who performed laboratory analyses; (fl Types of analyses; and (g) Results of analyses. 3. Monitoring Devices (a) Continuous monitoring devices Temperature, annular pressure, and injection pressure shall be measured at the wellhead using equipment of sufficient precision and accuracy. All measurements must be recorded at minimum to a resolution of one tenth of the unit of measure (e.g. injection rate and volume must be recorded to a resolution of a tenth of a gallon; pressure must be recorded to a resolution of a tenth of a psig; injection fluid temperature must be recorded to a resolution of a tenth of a degree Fahrenheit). Exact dates and times of measurements, when taken,must be recorded and submitted. Injection rate shall be measured in the supply line immediately before the wellhead. The Permittee shall continuously monitor and record the following parameters at the prescribed frequency: Monitoring Parameter Frequency fdliital ument Injection-rate(gallons per minute Hourlyrecorder Dail Injection Volume (gallons) Dail digitaltotalizer Total Cumulative Volume(gallons) Dail it totalizer Well head injection pressure si Hourlyrecorder Annular pressure si Hourlyrecorder Injection fluid temperature (degrees Fahrenheit Hourly digital recorder The Permittee is required to adhere to the preferred format below for reporting injection rate and well head injection pressure. An example of the preferred electronic data format: j DATE TIME INJ. PRESS (PSIG) INJ.RATE(GPMI 06/27/09 16:33:16 1525.6 65.8 06/27/09 17:33:16 1525.4 66.3 Each data line shall include four (4) values separated by a consistent combination of spaces or tabs. The first value contains the date measurement in the format of mm/dd/yy or mm/dd/yyyy , where mm is the number of the FINAL UIC Permit CA10910003 Page 19 of 29