Laserfiche WebLink
PART II. SPECIFIC PERMIT CONDITIONS <br /> A. REQUIREMENTS PRIOR' TO DRILLING, TESTING, CONSTRUCTING, OR <br /> j OPERATING <br /> 1. Financial Assurance <br /> The Permittee shall supply evidence of financial assurance prior to commencing <br /> Injection Well Drilling and Construction,in accordance with Section G of this part. <br /> 2. Field Demonstration Submittal Notification and Reporting <br /> (a) Prior tb each demonstration required in the following sections B through D, <br /> the Permittee shall submit plans for procedures and specifications to the U.S. <br /> Environmental Protection Agency Region IX Ground Water Office("EPA") <br /> for discussion and approval. The submittal address is provided in Section E, <br /> Paragraph 5. No demonstration in these sections may proceed without prior <br /> written approval from EPA. <br /> (b) The Permittee must notify EPA at least thirty (30) days prior to performhig <br /> any required field demonstrations after EPA 'approves the demonstration <br /> workplan, in order to allow EPA to arrange to witness if so elected. <br /> (c) The Permittee shall submit results of each demonstration required in this <br /> section to EPA within sixty(60) days of completion. <br /> California Division of Oil, Gas, and Geothermal Resources ("CDOGGR") reporting <br /> forms (such as a Well Summary Report) may be acceptable provided all information <br /> specified by this permit is included. <br /> B. WELL CONSTRUCTION <br /> 1. Locations of Injection Wells STIG-1,LEC-1,and LEC-2 <br /> Injection wells, LEC-1 and LEC-2, authorized under this permit, will be located at <br /> the STIG-LEC facility on 12751 North Thornton Road, in Lodi, California (See <br /> Appendix A, Figure 1). The STIG-1 well already exists on site (See Appendix A, <br /> Figure B). The proposed general location for the two new wells is found in <br /> Appendix A,Figure 3. <br /> (a) Prior to drilling any well, the Permittee must submit proposed field J454 <br /> coordinates (Section, Township, Range, with latitude/longitude) for the <br /> surface location of that specific well; for subsequent wells, also provide the <br /> distance between all wells, along with any justification for the proposed <br /> separation distance between the wells, both at the surface and at total depth. <br /> FINAL UIC Permit CA10910003 <br /> Page 5 of 29 <br />