WORK PLANS - Laserfiche WebLink

Home Browse Search

(b) After drilling is completed, the Permittee must submit final field coordinates (Section, Township, Range, with latitude/longitude) of any well constructed tinder this permit with the Final Well Constriction Report required under paragraph 9(a) of this section. If final well coordinates differ from the proposed coordinates submitted under paragraph (a) above,justification and documentation of any communication with and approval by EPA shall be included. 2. Testing during Drilling and Constructs Los and other tests ondu d during drilling and constriction shall include, at a minimum V7 1t on , e s, casing logs, and iniectson f rmation tests as outlined in 4'O CER§146.12 d . O Hole logs shall be conducted over the entire open hole ss i 3i�e a ow a conductor casing. Permittee shall conduct Formation Evaluation wireline logging operations and shall provide and use those results to estimate and report values for hydrocarbon saturation, porosity, lithology, rock mechanical properties for both the injection and confining zones identified within the permitted Opp �r geological sequence. a� Before surface, intermediate, and long string casings are set, dual induction/spontaneous potential/gamma ray/caliper (DIL/S 'JGR/CAL) logs will be run over the course of the entire open hole sequence after the well is drilled to each respective terminal depth. After each casing is set and cementing is completed, a spherically focused cement bond evaluation log(CBL)will be run over the course of the entire cased hole sequence(See Section D.2(a)(iv)of this part).-e" 3. Iniection Formation Testine 4 peg)-- s.ar'z 74")- /04 Injection formation information as described in 40 CFR 146.12(e), shall be determined through well logs and tests and shall include porosity, permeability, static formation pressure, and effective thickness of the injection zone. Reservoir compressibility (typically coefficient "c") must also be computed. A summary of results shall be submitted to EPA with the Final Construction Report required in paragraph 9(a) of this section and updated periodically with subsequent analyses. (a) Ground Water Testing During construction of the wells, information relating to ground water at these sites shall be obtained and submitted to EPA. This information shall include direct Total Dissolved Solids ("TDS") analysis of target injection formation water to demonstrate either the presence and characteristics of, or the lack of, any Underground Sources of Drinking Water ("USDW," as i defined in 40 CFR §144). FINAL UIC Permit CAI 0910003 Page 6 of 29