Laserfiche WebLink
Mons. ig equipment to be <br /> installed <br /> Manufacturer: <br /> Model Number: <br /> Sensor Type: Vapor Liquid Both. <br /> Sensor/Panel specifications. <br /> Location(s)for sen rs: 50415 <br /> Tank: �}m w&-s � r'�l Piping: <br /> Dispenser: I w1 �r ��` 5A-.,W <br /> C. Monitoring and response plan submitted[Section 2632(d)(1)&(2)]. <br /> 15. Any special accessories,fittings,coatings,or linings not inherent within the initial design of the 10 tank or double-wall <br /> UST. [Section 2631 (b)] <br /> A. Approved by a nationally recognized independent testing organization. <br /> B. Demonstration of integrity with the primary and/or secondary containment. <br /> 16. Tanks subject to floatation. [Section 2635(a)(7)] <br /> A. Anchored by deadman or slab. <br /> B. Anchors to be installed as specified by manufacturer. <br /> NC. Installation details provided on plans. <br /> D. Calculations provided. <br /> 17. SPILL AND OVERFILL PREVENTION <br /> Underground storage tank equipped with spill container and an overfill prevention system. (detail drawing of spill <br /> containers)/piping sump(s)required,including tank fill and all openings). <br /> A. Spill container[Section 2635(b)(1)]. <br /> If-made of metal,exterior wall protected from galvanic corrosion. <br /> Capacity:(minimum of five gallons) '5-q&4— <br /> Equipped <br /> Equipped with a drain valve which allows drainage of spill into primary container. <br /> Manufacturer: T N7 e / 4 <br /> B. Overfill prevention system does not allow for manual override and meets one of the following requirements: <br /> (1) Alert transfer operator at 90%full by restricting the flow into the tank or triggering an audible and <br /> visual alarm[Section 2635(b)(2)(A)] . <br /> Manufacturer: Model: <br /> (2) Restrict delivery flow to the tank 30 minutes before overfill when tank is filled at no more than 95% <br /> capacity and activates an audible alarm at least five minutes before overfill[Section 2635(b)(2)(8)]. <br /> Manufacturer: Model: <br /> (3) Provide positive shut off at no more than 95%capacity[Section 2635(b)(2)(C)]. <br /> Manufacturer: Model: <br /> (4) Provide positive shut-off of flow to the tank so that the fittings on top of the tank are not exposed to <br /> the product overfilling[Section 2635(b)(2)(D)]. <br />