Laserfiche WebLink
85400 ® rain shut-Off Valve Assembly <br /> Installation and Adjustment Instructions <br /> Removal <br /> First, remove the stainless steel retainer ring (85031) <br /> that holds down the foam filter and screen assembly. by I <br /> squeezing the ends together and pulling up. Remove the I <br /> foam filter. Loosen and remove the hex screw (using a 1/4" I <br /> drive ratchet and 3/16" hex socket) in the upper clamp. I <br /> I <br /> I <br /> � I <br /> I <br /> I <br /> I <br /> Figure 1: Wrench on Clamp <br /> Use a thin blade screwdriver to open or increase the gap <br /> in the upper clamp. Move the drain valve handle to the <br /> middle of the spill container. Figure 2: Handle in Raised Position <br /> 2. Slide the drain valve over the riser and firmly push <br /> Pull up on the handle to remove the ('r=:in valve assembly. down on the LOWER clamp (Figure 3). Make sure it <br /> Inspection is pushed all the way down and check to see that the <br /> Inspect the spill container f,, any dirt. sand, debris, and for upper clamp does not cover any of the riser slots. <br /> any damaged parts. Remove all dirt, gravel, debris. from <br /> the bottom of the spill container and replace any damaged <br /> 0-rings and parts. Remove any burrs on the black steel <br /> riser made by the removal of the adapter. <br /> Installation <br /> 1. Before installing the drain valve into the spill <br /> bucket, adjust the handle position so that it is L. <br /> approximately 1"from being over-center. After <br /> movir the handle. make sure the upper and lower �\ <br /> rings parallel by checking dimension"A° —it ' <br /> shou, k)e even all around (Figure 2). <br /> Figure 3:Install Drain Va e <br /> 3. Tighten the hex screw on the upper clamp to 80- <br /> 100 in-lbs (Figure 1). <br />