INSTALL_2009 - Laserfiche WebLink

Home Browse Search

Bulletin No. 82108 kW Fiber Glass Systems- October 1,2007 Bonded Double-Wall Sump Entry/Termination Fitting 3. Place two alignment rings on sump protector in place until Y." fitting instal- IY' ly entry/termination fitting and insert lation. through sump wall with the rings on 4. Dry fit primary pipe and rotate the » the outside of the wall. Locate the 1V two rings until the desired angle is threaded outlet to the desired loca- reached. Make alignment marks on e tion. If this fitting is used in an Open the rings, the fitting, and the sump wall. i to ti (Drainage) System, locate the 'V' Be sure to mark the rings so they can threaded outlet in the "South" posi- be placed in the same location and se- tion. Leave Y." plastic threaded outlet quence during bonding. NOTE: This fitting can be bonded to a Entry(Terminatm Fitting Body Sump Wall flat fiberglass surface only. DO NOT in- Alignment Rings stall on thermoplastic or round sumps. 1. Determine entry hole location and Outside Sump cut entry hole in sump wall using di- mensions in Table 1. (Maximum allow- able offset is 5'.) ——_ TABLE 1 -Fitting Dimensions _ T-- 1 Inside Sump Size A B C I HOLE DIA In. In. In. In. 1 3"x 2" 6.88 4.00 4.00 — ————— —_ 4"x 3 6.88 4.00 5.00 j ----- — 2. Using 40-60 grit sanding surface, sand the area around the hole where the alignment rings will bond to the s Retaining Ring sump. Lightly sand the rings. Remove dust and wipe with solvent(optional). A Adhesive Bead Adhesive Bead T----- -- T----- T—= —_ I I I 1 ! I Retaining Ring 0 Trademark of Varco UP,Inc. FIBER GLASS SYSTEMS-A NATIONAL OILWELL VARCO COMPANY www.smithfit)ercast.com 2700 W.65th ST.,LITTLE ROCK,AR 72209•501-5681!010-FAX 501-568-4465 25 S MAIN ST.,SAND SPRINGS,OK 74063•918-245-6651 •FAX 918-245-7566