Laserfiche WebLink
D. Results of Testing/Servicing <br /> Software Version Installed: ) <br /> Complete the following checklist: <br /> Yes ❑ No* Is the audible alarm operational? <br /> Yes ❑ No* Is the visual alarm operational? <br /> Yes ❑ N * Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> ❑ Yes No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> Cr'-N-/A operational? <br /> Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak,fails to operate,or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) 0r9u_ <br /> mpf+rensh.S z=s; O ISispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? 2MR; ❑No. <br /> ❑ Yes ❑ lyo* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fillpoint(s)and operating ro erl ? If so,at what percent of tank capacity does the alarm trigger? % <br /> ❑ Yes* No Was any monitoring equipment replaced? If yes, identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> ❑ Yes* ONo Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br /> Product; ❑Water. If yes,describe causes in Section E,below. <br /> Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> L977-es ❑ No* Is all monitoring equipment oerational per manufacturer's specifications? <br /> *In Section E below,describe how/and when these deficiencies were or will be corrected. <br /> E. Comments: Zf f® �' c>_�'• �_5:?�-� 11 7��'` ' r� y P4 r -5 ,1 <br /> d� s <br /> V <br /> Page 2 of 3 03/01 <br />