Laserfiche WebLink
31604.DSK <br /> WP-SFO <br /> ' C. Obtain all permits and pay all fees required by any utility or governmental <br /> agency having jurisdiction over this work. Arrange all inspections required <br /> by these utilities or agencies. Upon completion of work, furnish <br /> satisfactory evidence in writing to the Engineer that the work is acceptable <br /> to the regulatory authorities having jurisdiction. <br /> 1.4 SUBMITTALS <br /> I <br /> A. Provide complete manufacturer's descriptive information and shop drawings <br /> for all equipment, material, and devices furnished under this section, <br /> including but not limited to, certified outline drawings, arrangement <br /> drawings, elementary (schematic) control diagrams, demolition and <br /> modification elementary diagrams, interconnection and connection <br /> diagrams, in accordance with the provisions of Division 1, GENERAL <br /> REQUIREMENTS, of these Specifications. Use NEMA device <br /> designations and symbols for all electric circuit diagrams submitted. Make <br /> content of schematic (elementary) connection or interconnection diagrams in <br /> accordance with the latest edition of NEMA ICS 1. Provide the number of <br /> copies specified for the Engineer, Contractor, and Operation and <br /> Maintenance Manuals. <br /> B. Furnish submittal information for the following: <br /> 1. Rigid steel conduit and fittings. <br /> 2. Circuit identification system identifying actual number scheme to be <br /> used. <br /> 3. Motor control center. <br /> 4. Distribution panel backboard with mounting details and equipment <br /> layout. <br /> 5. Individual circuit breakers. <br /> 6. Individual motor starters. <br /> 7. Lighting and distribution panelboards. <br /> 8. Electric utility metering panel. <br /> C. In addition, the following specific information shall be provided: <br /> 1. One-line diagrams. <br /> 2. Elementary diagrams for motor starter panels. <br /> 3. Connection diagrams. <br /> 4. Maintenance instructions. <br /> 5. Material list. <br /> 6. Mounting and foundation details for the control panel. <br /> 7. Exterior Luminaires: Submit fastening details of luminaire to pole, <br /> ballast type, ballast location, and method of fastening. For light <br /> poles, submit wind loading, complete dimensions, and finish. <br /> 8. Lamps: Submit manufacturer's catalog data, including voltages, <br /> colors, approximate hours' life, approximate initial lumens, lumen <br /> maintenance curve, lamp type, and base. <br /> 9. Ballasts: Submit manufacturer's catalog data, including type, wiring <br /> diagram, nominal watts, input voltage, starting current, line current, <br /> input watts, sound rating, power factor, and low temperature <br /> i <br /> characteristics. <br /> BAE31604.AS.T1 <br /> 16005 2 ELECTRICAL SYSTEM <br />