Laserfiche WebLink
• Don respirator if required, and perform appropriate fit check <br /> • Put hood or head covering over head and respirator straps Tape the hood to the <br /> face of the respirator (if a full-face respirator is worn) <br /> • Don remaining PPE, such as safety glasses or goggles and hard hat <br /> If these procedures are instituted, at least one person shall remain outside the work area to <br /> ensure that each person entering has the proper protective equipment No persons shall be <br /> allowed to enter an EZ if they are not wearing the required PPE <br /> 5.3.2 Doffing Procedures <br /> Whenever a person leaves a Level C or higher work site, the following decontamination <br /> sequence will be followed <br />' Upon leaving the contaminated area, wipe or rinse contaminated materials ahs from <br /> the boots <br /> • Remove protective garments, equipment, and respirator <br /> All disposable clothing <br /> should be placed in plastic bags which are labeled with contaminated waste <br /> labels <br /> • Wash face and neck <br /> • Proceed to clean <br /> area and dress in clean clothing <br /> • Clean and disinfect respirator for next use <br /> All disposable equipment, garments, and PPE shall be bagged in two 6-mil (or thicker) plastic <br /> bags, properly labeled for disposal <br /> 5.4 Selection Matrix <br /> The level of personal protection selected will be based upon real-tune air monitoring of the <br /> work environment and an assessment by the Project FC of the potential for skin contact with <br /> contaminated materials The PPE selection matrix is given in Table 3. <br /> M7/11-29-94/RHSAWP/94-0037 JAF 5-4 <br />