Laserfiche WebLink
The annular space above the gravel packe.. should be sealed from the top of the <br /> gravel pack to the ground rsurfece. F. Neel of three to five feet Of sodium <br /> bentonite should be placed directly on top of the gravel peck. The remaining <br /> Annular space is sealed with a cement grout from the top of the bentonite to <br /> the ground 6urface. <br /> Two grout formulations ace acceptable. In those situations where a lower <br /> density grout is desirable, such as formation@ that have taken drill fluid, a <br /> cement-bentonite grout may be uaed. For general applications a cement-sand <br /> grout may be used. The cement-bentonite grout will consist of Portland <br /> Cement. finally ground sodium bentonite and potable .water in the proportions <br /> of 5.2 gallons of voter and 2 to 5 pounds of bentonite per 94-pound bag of <br /> cement, with an additional O.65 gallon of voter for each pound of bentonite. <br /> The cement-aand mix will consist of Portland Cement and clean 20-40 grade <br /> sand and potable water in the proportions of 5.2 gallons of water and 85 pounds <br /> of send per 94-pound neck of cement. <br /> The method of mixing either grout should result in a uniform and smooth <br /> mixture. For on-site mixing. the cement-bentonite grout should be blended by <br /> first preparing a smooth alurry of the bentonite and water by use of a het <br />°i mixer, and then the cement is added to this slurry through the het mixer. The <br /> cement-send grout should be blended in a sequence in which the cement is added <br /> lest. For either grout, water should not be held beck or extra water added. <br /> The aforementioned formulations assumes that all ingredients are dry. uniform, <br /> clean, uncontaminated, and lump free at the start of blending. <br /> Placement of Grout Seal Using one of the approved grouts. the remaining <br /> annulus will be grouted from the top of the bentonite scol to the ground <br /> surface. The grout will be pumped into the HSA; use of a tremae pipe is not <br /> required because the HSA acts as a tremae. The HSA will be filled with grout <br /> to the ground surface and then a section of HSA can be removed. This process <br /> will be repeated until all HSA' s have been removed. <br />�;?"j�-;.Ya.. .,,✓y=- X^:""-3";..:'�.. .. .. ..._...-r:'. ...»...- .,w,.......��.rv�.•_.>. _..-..+a.,.ems-.....-_..._-- - _ _ . <br />