INSTALL_2005 - Laserfiche WebLink

Home Browse Search

Sump Entry/Term!nation Ming with Bonded Fiberglass tkgnment Rings outside of the sump walls where sump wall.The metal ring must 1L The use of an industrial hot air the alignment rings are located. hold the assembly in position gun may speed up the curing Apply a thin coating of adhesive to while the adhesive cures. If the process. Do not overheat the bonding surface of the two assembly is not tight against the 12. Remove 1/4" plastic threaded out- rings that will bond to the sump sump wall, firmly press the entry let protector. Apply adhesive to walls. fitting against the outside sump the 1/4"fitting and screw into the 8. line up rings with alignment wall while pressing the metal ring 1/4"threaded outlet. Tighten to marks and press together firmly. against the alignment ring on the 4o in.-lbs. or IV2-2 turns past q. Slide the metal retaining ring over inside. hand tight. After installing fitting, inside section of sump fitting io. Do not disturb assembly until the be sure the interstitial space is free against the alignment rings until adhesive is cured. This includes from excess adhesive. Install a they are tight against sump wall. bonding of pipe to the entry fitting short hose and blow excess adhe- (A short section of 4"pipe may be and installing the threaded outlet sive through the air passage. used to drive the metal retaining fitting, Clean excess adhesive from 13. Connect only flexible tubing or ring over the fitting.)Be sure all bonding surfaces. See adhesive hoses to the 1/4"side-outlet there is an adhesive bead visi- kit instructions for cure times. Note: tubing or hoses must be ble between the rings and the rated to full vacuum. 114 hose barb adapter TERMINATION EXAMPLE using SUMP ENTRYITERMINATION FITTINGS Primary Pipe- L t Red Thread IIA g Minim¢ed Insertion ____________ \ Concentric Reducer _----- - - --- I ----- _ --T -------- �=== Maio sure air --- � passage is dear I c� ----------- ------ -------- -- ----- — ---__ `,Containment Pipe- standard 1!4"threads area"modified NPT'—the insertion of a J� `�.� Red Thread IIA standard spec male thread is minimized. �Sump EntrylTerrrinabon Fitting Smith Fibercast 7014 or 8014 adhesive is recommended. Spigot x NPT Adapter or Spigot x Spigot Nipple The 114"female threads are plastic and cannot be tightened Use concentric reducer to connect the sump entryttermination the same as a metallic thread.Tighten to 40 inAbs.or 112- fitting to secondary containment pipe; DO NOT USE clam shell 2 turns past hand tight. termination fittings with this style fitting. After installing a 1/4"NPT fitting,the passageways)to the piping interstitial space should be cleared with air pressure to insure that they are free ofthread sealant and/or adhesive. Itis the policy of Smith Fibercast to improve its products continually In accordance with that policy,the right is reserved to make changes in specifications,descriptions,and illustrative material contained in this bulletin as conditions warrant. The information con- tamed herein is general in nature and is not intended to express any warranty of any type whatsoever,nor shall any be implied. FbwGmw stems Aaionm Ca SMITH FIBERCAST DIVISION MEMOIR2700 J V, 2700 West 65th Street Little Rock,AR 72209 IC� ��1 rG9 '� �` Telephone(501)5684010 • Fax(501)568-4465 www.smithfibercast.com tint FT PRINTED IN U.S.A,504 ®Copyright 2004,Varco L.P.