Laserfiche WebLink
APP/SSHP <br /> Soil Excavation at California National Guard Armory <br /> Lodi, California <br /> Multi Start-up: Check Sensor Zero <br /> • If there is no alarm, and the sensor readings are in the range shown above, then the <br /> MultiRAE is ready for use. <br /> • Calibrate Monitor? <br /> • Fresh Air Calibration? <br /> o Make sure air is clean! <br /> • Multiple Sensor Calibration? <br /> • Single Sensor Calibration? <br /> • Modify Span Gas Value? <br /> • Change LEL/VOC Span Gas? <br /> o Choose (Y/+)to accept or(N/-) to move on, (MODE) to escape <br /> Multiple Sensor Calibration <br /> • At "Multiple Sensor Calibration" press "Y/+" key. <br /> • For CO/H2S/LEL mixed gas calibration the next screen should appear as above. <br /> Multiple Sensor Calibration <br /> • Press "Y/+" key to display this screen. <br /> • Attach calibration gas regulator to mixed gas cylinder. <br /> • Turn on calibration gas. <br /> • Attach calibration hose to MultiRAE. <br /> • Follow instructions on screen. <br /> o If you get this screen (NO GAS FLOW) check for gas flow, the MultiRAE will not <br /> perform span calibrations unless it senses calibration gas. Try again after you <br /> have verified that the gas is correct and it is flowing properly <br /> • Follow instructions on screen. <br /> • Disconnect regulator from gas cylinder when complete calibration. <br /> OTI E 35 <br />