Laserfiche WebLink
CL <br /> o <br /> ASSOCIATE S INC <br /> In July 1994, a RESNA field geologist observed the drilling of four additional groundwater <br /> monitoring wells (MW4, MW5, MW6, and MW7) at the site to further characterize subsurface <br /> conditions Groundwater samples collected from these additional wells contained no detectable <br /> petroleum hydrocarbons A detailed discussion of the Phase II Subsurface Investigation can be <br /> found in RESNA's "Summary Report, July 1994 Investigation,"dated August 26, 1994 <br /> In PHS/EHD correspondence dated March 1995, regulatory approval was given to sample wells <br /> MW3 and MW5 and wells MW4, MW6 and MW7 on an alternating semi-annual basis MW 1 <br /> and MW2 were to be sampled every quarter, conditions permitting <br /> To further evaluate the extent of residual soil contamination in the vicinity of the former <br /> underground fuel storage tank (UST), Smith Technology supervised the advancement of four soil <br /> borings (SB-1, SB-2, SB-3, and SB-4) on February 29, 1996 to depths of approximately 16 to 26 <br /> feet bgs Total petroleum hydrocarbons as gasoline (TPHg), benzene, toluene, ethylbenzene, and <br /> xylenes (BTEX) were detected above method detection limits at low to moderate concentrations <br /> in samples collected at depths between 10 and 15 feet bgs in borings SB-1, SB-2, and SB-3 A <br /> detailed discussion of this subsurface investigation can be found in Smith Technology's <br /> "Subsurface Investigation Report, " dated April 30, 1996 <br /> • GROUNDWATER MONITORING AND SAMPLING <br /> ATC personnel performed groundwater monitoring and sampling on March 24, 2000 Field <br /> work consisted of measuring the depth-to-water in wells MW1 through MW7, using an <br /> electronic water/product interface probe to determine if free product was present, purging and <br /> sampling wells MW1, MW4, MW6 and MW7, and servicing the passive skimmer placed in well <br /> MW2 <br /> Static groundwater elevations were measured in each monitoring well on March 24, 2000 <br /> Groundwater was measured at an average of approximately 10 13 feet bgs A groundwater <br /> gradient map was created with the March 24, 2000 data using a computer kriging program The <br /> gradient map, presented as Figure 2, depicts a southerly groundwater gradient averaging 0 01 ft/ft <br /> or approximately 58 feet/mile The water table elevation has increased an average of 2 26 feet <br /> since the previous measurements were collected in December 1999 Groundwater monitoring <br /> data are summarized in Table 1 <br /> On March 24, 2000, groundwater samples were collected by ATC from monitoring wells MW1, <br /> MW4, MW6 and MW7 Groundwater samples were collected from the monitoring wells after <br /> stabilization of pH, electrical conductivity (EC), and temperature All wells monitored were <br /> purged and sampled according to Smith Technology's Quality Assurance/Quality Control Plan <br /> on file with the PHS/EHD A minimum of approximately eight casing volumes of water was <br /> removed from each sampled well A dedicated disposable bailer was used to collect each water <br /> sample Field parameters and purged volumes are shown on well purge logs included in <br /> Attachment I <br /> 62581%QUARTLY\1QR-2000 DOC 2 <br />