COMPLIANCE INFO_1985-2005 - Laserfiche WebLink

Home Browse Search

FV, Site Preparation and Ingllation Instructions .1 TLS -350 UST MonitorinlWstem IMPORTANT: THIS IS A CONTROL DRAWING ONLY AND DOES NOT REFLECT THE ACTUAL LOCATIONS OF CONDUIT ENTRY (SEE NOTE 7 BELOW). L .�IWARNING: IN INSTALLATION AND USE OF THIS PRODUCT, COMPLY WITH THE NATIONAL ELECTRICAL CODE; FEDERAL, STATE AND LOCAL CODES. IN ADDITION, TURN OFF POWER AND TAKE RIGID OTHER NECESSARY PRECAU- CONDUIT TIONS DURING INSTALLATION, SERVICE AND REPAIR TO PREVENT PERSONAL INJURY, PROPERTY BARRIER GROUND LOSS AND EQUIPMENT DAMAGE. CHASSIS GROUND .114 WARNING: DISCONNECT ALL POWER AC NEUTRAL BEFORE MAKING ANY CONNEC- TIONS TO PREVENT DEATH, SERI- AC LINE OUS INJURY, EXPLOSION, OR ELECTRICAL SHOCK. MONITOR MUST NEVER BE OPERATED UN- LESS THE FRONT COVER IS CLOSED OVER THE BARRIER TER- MINALS IN THE INTRINSICALLY SAFE AREA. RIGID rrnnini 11T NOTES: 1. WIRING TO PROBES AND SENSORS MUST BE GAS AND OIL RESISTANT SIZES FROM AWG #18 TO AWG #14. BARRIER GROUND WIRING MUST BE AWG #12 OR LARGER. 2. CONNECT WITH #12 AWG (OR LAR- GER) CONDUCTOR THE BARRIER GROUND TO THE EARTH GROUND BUS AT THE POWER DISTRIBUTION PANEL. 3. J DENOTES FIELD WIRING CON- NECTION USING WATERPROOF CONNECTORS SUPPLIED WITH THE PROBE(S) AND SENSOR(S). 4. INTRINSICALLY SAFE WIRING SHALL BE INSTALLED IN ACCORD- ANCE WITH ARTICLE 504-20 OF THE NEC ANSI/NFPA 70, 1990. 5. TO MAINTAIN INTRINSIC SAFETY AND PROPER SYSTEM OPERATION, PROBE AND SENSOR WIRING MUST BE INSTALLED WITHIN SEALED CONDUIT. 6. ELECTRICAL RATING POWER IN- PUT — 120 VAC, 50/60 HZ, 600 WATTS MAXIMUM. 7. SEE FIGURE 8 IN THIS MANUAL FOR ACTUAL LOCATION OF CONDUIT ENTRY INTO TLS -350 MONITOR. 8. REFER TO LINE LEAK DETECTOR "SITE PREPARATION AND INSTAL- LATION INSTRUCTIONS," MANUAL NO. 576013- 764. Ir�raaraoonm 10 Figure 9a. Typical TLS -350 System Wiring Diagram.