COMPLIANCE INFO_2006-2012 - Laserfiche WebLink

Home Browse Search

Hr%b Hpprovea ivivi—rleaiy r-nase a cvr% system—vK-zu i-H kwu ivozziel rage y 1.3.5 Install t ini-Boot and test nozzlq operatioaLing the procedure from Sections 1.1.3 through 1.1.8. 1.4 Healy Part No. 469 Handle Cover Replacement 1.4.1 Grasp the lower edges of the Handle Cover (see Sections 1.7 & 1.8, Item 6) and pull the cover off with an upward motion. 1.4.2 Installation is the reverse of this procedure. Be sure the pointed wings on the front of the cover are slid under the Scuffguard. 1.5 Healy Part No. 6358 Handguard Replacement 1.5.1 This is best done with the nozzle detached from the hose. The front and rear guard pins must be removed. Back up the head side of the pin with a suitable socket and drive out the guard pins using a 3/32" drive pin punch or equivalent. The spring-loaded hold-open clip will pop out when the rear pin is removed. Be sure to observe the orientation of the spring so it can be properly reinstalled. 1.5.2 Remove the Handguard (see Sections 1.7 & 1.8, Item 10) carefully. The lever will drop down and the lever pivot pin will be free and could possibly slide out. Place the new Handguard into position and install a new front guard pin (Figure 1, Item 13) through the Handguard. Do not peen at this time. 1.5.3 Position the hold-open clip (see Sections 1.7 & 1.8, Item 7) over the handguard. Insert a new rear guard pin (see Sections 1.7 & 1.8, Item 8) through one ear of the clip. handguard and approximately 1/8" through the casting. Slide the coil spring (see Sections 1.7 & 1.8, Item 9) into position with the "hook" on the hold-open clip. Push in the spring so the pin passes through the coil and into the other ears on the casting, handguard and clip. Be sure the hold-open clip is installed properly before peening-over the free ends of the two pins. 1.6 Healy Part No. 6130-4 Lever Replacement 1.6.1 Remove the Handguard using the instructions in Section 1.5 to expose the Lever. There is a washer around the plunger under the Lever. Observe how these are installed and be sure to re-use them with the new Lever. 1.6.2 With the Lever released, the white plunger will pull back towards the casting and make it difficult to re-install the pin on a new Lever. Use a small screwdriver to reach through one mounting hole in the new Lever and engage Healy Systems, Inc. Website: http://www.healysystems.com 18 Hampshire Drive Email: sales@healysystems.com Hudson, New Hampshire 03051 USA Telephone 603.882.2472 ARB Approved Installation, Operation and Maintenance Manual (April 8, 2005) Fax 603.882.5189 tw"l Healy Systems, Inc. —the innovative leader of Stage II vapor recovery equipment