Laserfiche WebLink
HKCs fipproveo luM—rleaiy i-nase ii Cvm oystem— vm-Lu i-/-x(yuu Nozzle) rage o <br /> Testing the New Sp , <br /> All spout replacements must be tested to ensure the installation has <br /> been completed correctly. <br /> 1.2.8 Dispense product into a container deep enough to cover the small hole near <br /> the tip of the spout and verify that the dispensing rate is between 6.0 — 10.0 <br /> gpm with the nozzle lever held in the full open (handheld) position. While <br /> dispensing, with the nozzle lever held in the full open (handheld) position, <br /> immerse the spout until the hole is covered. If shutoff does not occur, turn off <br /> the dispenser, remove the spout, and check the o-rings. Replace the o-rings <br /> as necessary (Part No. 6206-OR Spout O-Ring Kit) and repeat Sections 1.2.7 <br /> through 1.2.8. If shutoff does occur, go to Section 1.2.9. <br /> Note: If repeated attempts to repair nozzle does not result in <br /> successful shut off, replace the nozzle. <br /> 1.2.9 Repeat Section 1.2.8 two additional times (3 tests total) to ensure that the auto <br /> shutoff feature is working properly. There should be no hesitation to the <br /> shutoff; it should be quick and positive. If shutoff tests are successful, the <br /> nozzle can be put back into service. If either additional shutoff test fails, turn <br /> off the dispenser, remove the spout, and check the o-rings. Replace the o- <br /> rings as necessary (Part No. 6206-OR Spout O-Ring Kit) and repeat Sections <br /> 1.2.7 through 1.2.9. <br /> Note: If repeated attempts to repair nozzle does not result in <br /> successful shut off, replace the nozzle. <br /> 1.3 Healy Part No. 6030 Scuffguard Replacement <br /> 1.3.1 Remove the Mini-Boot using the procedure from Section 1.1. <br /> 1.3.2 Slide a long screwdriver under the Scuffguard (see Sections 1.7 & 1.8, Item 5) <br /> in the area of the main valve cap nut on the top of the nozzle. <br /> 1.3.3 Pry upward to clear the top of the main valve cap, and then pull steadily <br /> toward the spout to remove. <br /> 1.3.4 Installation is the reverse of this method. It works best with the butt of the <br /> nozzle held in a vise. In cold weather the Scuffguard may not be pliable <br /> enough to use the above method, carefully (do not damage the nozzle) cut the <br /> old Scuffguard off with a knife and replace it with a new "warmed" Scuffguard <br /> by using the reverse of the step above. <br /> Healy Systems, Inc. Website: http://www.healysystems.com <br /> 18 Hampshire Drive Email: sales@healysystems.com <br /> Hudson, New Hampshire 03051 USA Telephone 603.882.2472 <br /> ARB Approved Installation, Operation and Maintenance Manual (April 8, 2005) Fax 603.882.5189 <br /> Healy Systems, Inc. —the innovative leader of Stage 11 vapor recovery equipment <br />