Laserfiche WebLink
13 '�J11(81 <br /> D. Results of Testing/Servicing O=NE' ll <br /> Software Version Installed: 1.001 <br /> Com tete the following checklist: <br /> ® Yes ❑ No* Is the audible alarm operational? <br /> ® Yes ❑ No* Is the visual alarm operational? <br /> ® Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br /> operation? <br /> ❑ Yes ❑ No. If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.,modem)operational? <br /> 0 N/A <br /> * Yes ❑ No* For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak, <br /> ❑ N/A fails to operate,or is electrically disconnected? If yes:which sensors initiate positive shut-down? (Check all that apply) N Sump/Trench Sensors; <br /> ❑Dispenser Containment Sensors. <br /> Did you confirm positive shut-down duetoleaks and sensor failure/disconnection? 0 Yes; ❑No. <br /> ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e., no mechanical overfill prevention valve is <br /> N/A installed),is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly? If so,at what percent of tank capacity <br /> does the alarm trigger.? % <br /> ❑ Yes ED No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name <br /> and model for all replacement parts in Section E,below. <br /> El Yes* N No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> I I I ❑Product; ❑Water. If yes,describe causes in Section E,below. <br /> Z Yes ❑ No' Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> H Yes ❑ No' Is all monitoring equipment operational per manufacturer's specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> DISPENSER SENSORS ARE STAND ALONE , LIQUID AND DISCONNECTION POWER <br /> E. Comments: DOWN DISPENSER DIRECTLY <br /> Monitoring System Certification Page 2 of 4 2/21/07 <br />