Laserfiche WebLink
i <br /> INSTALLATION PROCEDURES <br /> LiEL <br /> GENERAL <br /> Note:Do not lower or lift the pump by means of the motor cable. <br /> The loose data plate supplied with the pump should be placed close to the <br /> installation site. <br /> 8.INSTALLING THE CABLE PLUG-TO THE MOTOR <br /> The cable plug supplied with the motor is factory-greased. <br /> Check that the plug is greased correctly,see Figure 6. <br /> To install the cable plug,proceed as follows: Figure 6 <br /> 1. Check that the cable is of the correct type, <br /> cross-section and length. <br /> 2.Check that the mains on the location has I f <br /> correct connection to ground. 11`.JI <br /> 3.Check that the motor socket is clean and dry. i <br /> 4. Press the cable plug into the motor socket. <br /> The plug will only fit one way,see Figure 7. <br /> 5. Install and tighten the four nuts,see Figure 7. <br /> When the plug has been installed,there must not <br /> be a clearance between the motor and the <br /> cable plug. <br /> i <br /> e <br /> Figure 7 <br /> 9.INSTALLING THE CABLE GUARD <br /> To fit the cable guard,proceed as follows: <br /> 1. Make sure that the motor lead lies flat in the cable guard. <br /> 2.The two flaps of the cable guard must engage with the <br /> upper edge of the pump sleeve,see Figure 8. <br /> 3. Fasten the cable guard to the cap plug with the four screws supplied, <br /> see figure 9. <br /> i <br /> 11r! <br /> Il r <br /> a <br /> b p <br /> 9y <br /> Figure 8 <br /> Figure 9 <br /> i 7 <br /> A <br /> Y <br /> x <br />