Laserfiche WebLink
z <br /> t <br /> INSTALLATION PROCEDURES <br /> 10. PIPING <br /> • The pump should only be gripped <br /> by the two flats at the top of the <br /> pump,as shown in Figure 10. <br /> t _ <br /> • The pump can be installed <br /> vertically or horizontally. During <br /> operation,the pump must always <br /> be completely submerged Figure 10 <br /> in water. <br /> • When plastic pipe is used,a stainless steel safety wire is recommended for <br /> lowering and lifting the pump.Fasten the wire to the eyelet on the pump, <br /> as shown in circle insert 2, Figure 11. <br /> • The threaded joints must be well <br /> cut and fit together tightly to <br /> ensure that they do not <br /> work loose. <br /> 11. INSTALLING THE PUMP <br /> Installation Depth <br /> The dynamic water level should A I <br /> always be above the pump.See fig. <br /> 11. � <br /> A= Dynamic water level <br /> B=Static Water Level <br /> C=Minimum 3 inch well diameter D <br /> D=Drawdown <br /> E= Installation depth below static <br /> water level.Maximum 500 feet <br /> Procedures <br /> To install the pump,follow j <br /> these steps: <br /> f 1. Install the enclosed data Insert 2 E <br /> plate sticker at the <br /> well head- <br /> 1 2.Check the well for proper <br /> clearance —the well Figure 11 <br /> must be at least 3inches in diameter.It is a good <br /> idea to check the well for clearance using a <br /> plumb ring(2.95 0 x 10 in.). <br /> 3.Attach the first section of riser pipe to the pump. <br /> C <br /> 4 <br />