Laserfiche WebLink
19.ASSEMBLY OF PUMP AND MOTOR <br /> To assemble pump end and motor, proceed as follows: <br /> 1.Place the motor horizontally in a vice and tighten it, see Figure 12. <br /> i <br /> 2.Grease the motor shaft end with the grease supplied with the <br /> motor. <br /> 3.Screw the pump end on the motor.A spanner may be used on the <br /> clamping faces of the pump part, see Figure 12. <br /> 4.Install cable guard as described on page 7. <br /> When pump end and motor have been assembled correctly, there must not be <br /> a clearance between pump end and motor. <br /> To disassemble reverse procedure. <br /> i <br /> O <br /> Use pump vise here. <br /> sj I <br /> 2.91 inches, <br /> { 1.2 inches <br /> _ t <br /> T <br /> Figure 12 <br /> a <br /> 12 <br /> :I <br /> � I <br />