Laserfiche WebLink
MSDS 21 <br /> July 1, 2002 <br /> SECTION 6-Accide tal Release Measures splash guard or side shields. <br /> Steps to be taken in case material 15 released or spilled: SECTION 9-Physical and Chemical Properties <br /> Ventilate area. Remove sources of ignition.Prevent skin and eye <br /> contact and breathing of vapor.If the material contains,or is mixed Evaporation Rate Slower than Ether <br /> with an isocyanate activator/ ardener: Wear a positive-pressure, Solubility in water NIL <br /> supplied-air respirator(NIOSF approved TC-19C),eye protection, Vapor Density Heavier than air <br /> gloves and protective clothing Pour liquid decontamination solution Approx. boiling range(°C) No Data Available <br /> over the spilland allow to sit�tocyanate <br /> least 10 minutes. Typical Approx.freezing range(°C) -92-133°(C) <br /> decontamination solutions for containing materials are: Gallon weight(lbs./gal) 6.65- 16.71 <br /> 20%Surfactant (Tergitol TM 10)and 80%Water OR 0-10% Specific gravity 0.80 2.00 <br /> Ammonia,2-5%Detergent an Water(balance) Pressure can be Percent volatile by volume 7.09-100.00 <br /> generated. Do not seal waste containers for 48 hours to allow CO2 to Percent volatile by weight 5.00-100.00 <br /> vent. After 48 hours,material may be sealed and disposed of Percent solids by volume 0.00- 92.91 <br /> properly. If material does not ontain or is not mixed with an Percent solids by weight 0.00- 95.00 <br /> isocyanate activator/hardener:Wear a properly fitted air-purifying <br /> respirator with organic vapor cartridges(NIOSH approved TC-23C), SECTION 10-Stability and Reactivity <br /> eye protection,gloves and protective clothing.Confine,remove with <br /> inert absorbent,and dispose o properly. Stability: <br /> Stable <br /> SECTION 7-Hand Jing and Storage Incompatibility(materials to avoid): <br /> water,alcohols,amines <br /> Precautions to be taken in handlingnd storing: Hazardous decomposition products: <br /> Observe label precautions.If combustible(flashpoint between 100- CO,CO2,smoke,and oxides of any heavy metals that are reported in <br /> 200°F),keep away from heat,sDarks and flame.If flammable "Composition,Information on Ingredients"section. <br /> (flashpoint less than 100°F),also keep away from static Hazardous polymerization: <br /> discharges and other sources of ignition.If material is extremely Will not occur. <br /> flammable(flashpoint less than 20°F)or flammable,VAPORS MAY Sensitivity to static discharge: <br /> IGNITE EXPLOSIVELY OR CAUS FLASH FIRE,respectively.Vapors For flammable materials(flashpoint less than 100°F)and <br /> may spread long distances. Prevent buildup of vapors.Close container combustibles(flashpoint between 100-200°F)if heated above the <br /> after each use.Ground containers when pouring.Wash thoroughly flashpoint,solvent vapors in air may explode if static grounding and <br /> after handling and before eating or smoking.Do not store above bonding is not used during transfer of this product. <br /> 120°F.If product is waterbased,do not freeze. Sensitivity to mechanical impact: <br /> Other precautions: Not Applicable <br /> If material is a coating:do not sond,flame cut,braze or weld dry <br /> coating without a NIOSH approv d respirator or appropriate SECTION 11-Additional Information <br /> ventilation,and gloves. <br /> SECTION 8-Exposure Con Is or Personal ProbProtectionPRODUCT CODE INGREDIENTS(Product Specific) <br /> Engineering controls and work practiges: 501HTm Acrylic Polymer-D,Butyl Acetate,Carbon Black(0.6%), <br /> Ventilation: Ethylbenzene(0.2%*@),Methyl Amyl Ketone <br /> Provide sufficient ventilation in volume and pattern to keep GAL WT•8.22 WT PCT SOLIDS:52.26 VOL PCT SOLIDS:44.95 <br /> contaminants below applicable in <br /> SOLVENT DENSITY:7.14 VOC LE: 3.9 VOC AP: 3.9 <br /> pp a posure limits. FLASH POINT:73°F to below 100°F H:2 F:3 R.0 OSHA STORAGE:IC <br /> Respiratory. TSCA STATUS:In compliance PHOTOCHEMICALLY REACTIVE:NO <br /> Do not breathe vapors or mists. If this product contains <br /> isocyanates or is used with an isocyanate activator/hardener,wear a <br /> positive-pressure,supplied-air re pirator(NIOSH approved TC-19C) <br /> while mixing activator/hardenerith paint,during application and 502H7" Acrylic Polymer-C,Butyl Acetate,Petroleum Naphtha,Propylene <br /> until all vapors and spray mist ar exhausted. If product does not Glycol Monomethyl Ether Acetate,Red Iron Oxide Light <br /> contain or is not mixed with an is cyanate activator/hardener,a GAL WT:14.20 WT PCT SOLIDS:71.79 VOL PCT SOLIDS:46.28 <br /> properly fitted air-purifying respi for with organic vapor SOLVENT DENSITY:7.46 VOC LE: 4.0 VOC AP: 4.0 <br /> cartridges(NIOSH TC-23C)and p rticulate filter(NIOSH TC-84A)may FLASH POINT:73°F to below 100*F H:2 F:3 R:0 OSHA STORAGE:IC <br /> be used. Follow respirator mane cturer s directions for respirator TSCA STATUS:In compliance PHOTOCHEMICALLY REACTIVE:NO <br /> use.Do not permit anyone witho protection in the painting area. <br /> Individuals with history of lung or breathing problems or prior <br /> reaction to isocyanates should nol use or be exposed vapor or spray 503HTm Acrylic Polymer-D,Ethylbenzene(0.1%*@),Lead Chromate <br /> mist if product contains or is mixeJ with isocyanate (58.0%*@),Methyl Amyl Ketone,Propylene Glycol Monomethyl Ether Acetate, <br /> activators/hardeners. Titanium Dioxide,Xylene(1-1%*@) <br /> Protective clothing: GAL WT:16.71 WT PCT SOLIDS:77.53 VOL PCT SOLIDS:50.91 <br /> Neoprene gloves and coveralls ar recommended. SOLVENT DENSITY:7.65 VOC LE: 3.8 VOC AP: 3.8 <br /> Eye protection: FLASH POINT:73°F to below 100°F H:2 F:3 R.0 OSHA STORAGE:IC <br /> Desirable in all industrial situation4.Goggles are preferred to TSCA STATUS:In compliance PHOTOCHEMICALLY REACTIVE:NO <br /> prevent eye irritation. If safety gsses are substituted,induce <br /> 8 <br /> MSDS 21 <br /> July 1,2002 <br /> © 2001-2002 E.I. du Pont de Ne ours and Company.All rights reserved. Reproduction or translation of any part of this <br /> work beyond that pe fitted by U.S. Copyright laws without the written permission of du Pont is <br /> unlawful and strictly forbidden. <br />