Laserfiche WebLink
' 1 SECTION 08110 <br /> 2 <br /> 3 PRESSED METAL FRAMES <br /> 4 <br /> 5 <br /> 6 PART 1 : GENERAL <br /> 7 <br /> e 1.01 DESCRIPTION <br /> 9 <br /> 10 The work of this section consists of furnishing and installing pressed metal door frames. <br /> 11 <br /> 12 1.02 RELATED WORK SPECIFIED ELSEWHERE <br /> ' 13 <br /> 14 A. Section 07920: Caulking and Sealants <br /> 15 <br /> ' 16 B. Section 08100: Metal Doors <br /> 17 <br /> 18 C. Section 08200: Wood Doors <br /> 19 <br /> 20 D. Section 08710: Finish Hardware <br /> 21 <br /> 22 1.03 STANDARD AND INDUSTRY SPECIFICATIONS <br /> 23 <br /> za Except as herein modified, all work shall conform to Steel Door Institute (SDI) "Technical <br /> 25 Data Series 100". <br /> 26 <br /> 27 1.04 SUBMITTALS <br /> 28 <br /> 29 A. In accordance with Section 01300. <br /> 30 <br /> 31 B. Submit for approval in accordance with following requirements: Indicate dimensions, <br /> 32 gauges, profiles, joint construction, location and gauge of hardware reinforcement; door <br /> 33 clearances; type, gauge, size and location of frame anchors; shop finishes. <br /> 34 <br /> 35 <br /> ' 36 PART 2: MATERIALS <br /> 37 <br /> 38 2.01 GENERAL <br /> 39 <br /> I 40 A. Factory prefit hollow metal doors to their respective pressed metal frames. <br /> 41 <br /> 42 B. Prepare pressed metal frames at factory for installation of hollow metal doors and hardware. <br /> 43 Welding of hinges to frames is not permitted. Mortise, reinforce, drill and tap frames to <br /> 44 template to receive mortised hardware. Provide reinforcing plates for surface applied <br /> 45 hardware. Reinforcing shall be concealed. Use of bolts or rivets for reinforcement is not <br /> ' 46 permitted. Preparation for hardware shall conform to ANSI At 15 where applicable, except <br /> 47 reinforcing for butts shall be minimum 3/16-inch thick, and except that reinforcing for <br /> 48 closers and applied hardware shall be of size and location as required for specific hardware <br /> 49 to be installed. Fabricator shall verify type, size and location of all required hardware. <br /> 50 <br /> PRESSED METAL FRAMES <br /> 042794 08110-1 <br />