ARCHIVED REPORTS - Laserfiche WebLink

Home Browse Search

C. The Contractor shall cooperate with the Owner and provide assistance for the inspection of the electrical system under this Contract. The Contractor shall remove covers, provide access, ' operate equipment, and perform other reasonable work which, in the opinion of the Owner, will be necessary to determine the quality and adequacy of the work. 1.8 JOB CONDITIONS A. The Contractor shall make all arrangements and pay the costs thereof for temporary services ' required during construction of the project, such as temporary electrical power and telephone service.Upon completion of the project, remove all temporary services, equipment, material ' and wiring from the site as the property of the Contractor. B. The Contractor shall provide adequate protection for all equipment and materials during shipment, storage and construction. Equipment and materials shall be completely covered with two layers of plastic and set on cribbing six inches above grade so that they are protected from weather, wind, dust, water, or construction operations. Equipment shall not be stored outdoors without the approval of the Owner. Where equipment is stored or installed in moist areas, such as unheated buildings, provide an acceptable means to prevent moisture damage, such as a uniformly distributed heat source to prevent condensation. ' C. The elevation of the project site is approximately 25 feet above sea level. All equipment shall be derated as recommended by the manufacturer or in accordance with ANSI C37.30. ' D. The normal outdoor, not in direct sunlight, ambient temperature range of the job site will vary between 20 to 115 degrees Fahrenheit, the indoor normal controlled temperature range will ' vary between 40 to 90 degrees Fahrenheit. All equipment shall be rated to operate in these temperature ranges or provisions, at no additional cost. 1.9 UTILITY SERVICES A. It is the responsibility of the Contractor to make all equipment approval arrangements and scheduling with the power Utility company connected with this project. B. The following lists some of the Contractors responsibilities: 1. Ensure that the metering equipment installation is in accordance with requirements of ' Utility power company by submitting drawings, sketches, catalog information, and other appropriate material for power company approval. ' 2. Obtain from the Utility power company the location, dimensions, construction methods, and mounting arrangements for new electrical service. ' ELECTRICAL 16000 - 9