Laserfiche WebLink
Assembling Kit Components . . <br /> Attaching Probe Canister Stabilizer Rings (4-Inch Risers) <br /> @000ibe (Dt <br /> 1. Remove a new probe from it's shipping container, or remove a probe to be retrofitted from its tank. Lay the <br /> probe on the surface in an area of the site protected from vehicle traffic. If you are retrofitting a probe, remove <br /> and discard the existing canister rings,floats and boot. ONLY the white boot is compatible with the Ethanol- <br /> Blended Gasoline Float Kit. <br /> 2. Open the Ethanol-Blended Gasoline Float Kit. Set the adjustable arms of the rings for a 4-inch riser(see <br /> Figure 2) as required. Install the two stabilizer rings onto the probe canister as shown in the figure. Note:you <br /> must slide the bottom ring up over the probe shaft and onto the lower end of the canister. <br /> After setting arms(see insert) install top stabilizer ring.Orient <br /> locking tabs as shown,and then slide ring over top of canister <br /> until tabs snap into groove in canister. <br /> Ili <br /> �1 <br /> CANISTER STABILIZER RING SETTINGS <br /> Up ♦ <br /> Probe <br /> canister <br /> 4-inch riser <br /> set 4 arms of ring <br /> as shown. <br /> 006-2.eps <br /> After adjustment(see insert)install bottom stabilizer <br /> ring.Orient locking tabs as shown,and then slide <br /> ring up over probe shaft and onto bottom of canister, `/ Probe shaft <br /> until tabs snap in groove. <br /> Figure 2. Installing Probe Canister Spacer Rings <br /> 4 <br />