Laserfiche WebLink
Assembling Kit Components onto Probe Assembling Floats onto Probe Shaft <br /> Assembling Floats onto Probe Shaft <br /> The Product Float, Ethanol /Water Float assembly and the White Boot must be assembled on the probe shaft in <br /> the exact sequence and orientation shown in Figure 3. <br /> IMPORTANT! <br /> Failure to push the boot as far as possible onto the probe shaft could cause the boot and float(s)to <br /> fall into the tank.The boot must be pushed on until it"locks"on the probe shaft. <br /> Handle the probe carefully. Striking or dropping the probe will result in loss of calibration and could cause <br /> permanent damage. <br /> 4-inch <br /> I=, âś“Product Float- <br /> I slide on probe <br /> shaft first. <br /> I I I <br /> i <br /> UPEthanol/Water Float Ass'y- <br /> slide on probe shaft second. <br /> i <br /> I <br /> I I <br /> I I <br /> I I White Boot- <br /> I I <br /> slide on probe <br /> I I shaft last <br /> I <br /> J006-3.eps <br /> I <br /> Figure 3. Example installation of Probe Floats and White Boot <br /> 5 <br />