COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

Project No.4-419-0381 August 29,2019 Page No. 7 such as swelling,cracking,shrinking,or discoloration of the material.When any of these signs are detected, it means that the glove has undergone a physical change due to chemical contact and will no longer provide chemical protection. Any glove that shows signs of degradation or damage will be taken out of service immediately and replaced with a new pair. Foot Protection: hi accordance with OSHA 29 CFR 1910.136(a), all field team personnel shall wear protective footwear when working within the project site or areas where there is danger of foot injuries due to falling or rolling objects, or objects piercing the sole, and where such employee's feet are exposed to electrical hazards. All foot protection will meet guidelines set forth by ANSI Z41-1991. Foot protection will be inspected for cuts, holes, tears, cracks, worn soles, and other damage that could compromise the footwear's protection. Outsoles should be kept free of stones,tacks,nails, and other debris.Foot protection should be cleaned according to the manufacturer's instructions. Eye Protection: Field team personnel will wear impact resistant safety glasses with attached side shield in compliance with OSHA 29 CFR 1910.133.Eye protectors shall meet the following minimum requirements: • They shall provide adequate protection against the particular hazards which they are designed. • They shall be reasonably comfortable when worn under the designated conditions. • They shall fit snugly and shall not unduly interfere with the movement of the wearer. • They shall be durable. • They shall be capable of being disinfected. • They shall be easily cleaned. • Eye Protection should be kept clean and in good repair. Employees whose vision requires the use of corrective lenses in spectacles,and who are required by OSHA Standard 1910.133 to wear eye protection, shall wear goggles or spectacles of one on the following types: • Spectacles whose protective lenses provide optical correction. • Goggles that can be worn over corrective spectacles without disrupting the adjustment of the spectacles. • Goggles that incorporate corrective lenses mounted behind the protective lenses. Design, construction, testing and use of devices for eye and face protection shall be in accordance with ANSI Z87.1-1989 Ear Protection:Field team personnel will be required to wear hearing protection devices in accordance with OSHA 29 CFR 1910.95 standard(ear plugs or muffs). As a general rule if field team members must raise their voices to be understood at a distance of 3 feet they will wear the required ear protection listed above. Safety Helmet:All field team personnel shall wear a protective helmet when working in any area at the Site in compliance with OSHA 29 CFR 1910.135(a)(1). All Safety Helmets will meet performance guidelines set forth by ANSI Z89.1-1986, American National Standard for Personal Protection-Protective Headware for Industrial Workers Requirements.All employees will follow the ANSI standard addressing service life of the safety helmet. All employees will inspect their safety helmet daily for signs of dents, cracks, penetration,and any damage due to impact,rough treatment,or wear.Any safety helmet that does not pass the visual inspection should be taken out of service and replaced. 3.3 Hazard Protection The following potential hazards were described in the previous chapter of this plan: Ll SALEM engineering group. inc.