Laserfiche WebLink
AVERSTISSEMENT-RISQUE D'EXPLOSION-AFIN Section 3 <br /> D'EVITER TOUT RISQUE D'EXPLOSION,S'ASSURER QUE Setting the Flow Rate for Sampling from.8 to 4.0 LPM <br /> L'EMPLACEMENT EST DESIGNE NON DANGEREUX AVANT <br /> DE CHANGER LA BATTERIE. <br /> Operating Instructions <br /> Performance Profile ON green LED <br /> Accuracy:+/-5%of the flow set int FAULT orange LED is <br /> cy: point <br /> lit when flow cannot be <br /> Constant Flow Range:Minimum of 8 hours of operation maintained. <br /> 1.5 LPM up to 15 inches of water backpressure ® BATTERY red LED is lit <br /> 2.0 LPM up to 35 inches of water backpressure for low battery condition. <br /> 2.5 LPM up to 30 inches of water backpressure <br /> 3.0 LPM up to 20 inches of water backpressure SET button is to be pressed <br /> 4.0 LPM up to 8 inches of water backpressure ON/OFF button when using the Arrow keys <br /> to adjust flow. <br /> Press to tum ON,pump will begin running at <br /> Pump Run Time with Sampling Filters <br /> previous set flow rate. Press and hold for 3 seconds to turn off. <br /> Flow Rate in LPM <br /> Filter type and size 2.0 2.5 3.0 4.0 Nate. Connect a representative sampling filter cassette using 1/4 inch <br /> 37mm 0.8u PVC 23 hr 19 hr 18 hr 16 hr tubing to the pump prior to setting Flow Rate for optimal performance. <br /> 37 mm 0.8u MCE 21 hr 16 hr 16 hr 13 hr <br /> 25 mm 0.8u MCE 15 hr 12 hr 10 hr — Setting the flow rate <br /> 25 mm 0.45u MCE 11 hr 10 hr — — <br /> l. Connect sampling filter with hose to Io , <br /> pump. --- <br /> 2. To measure flow rate have a _ QD_ <br /> rotometer/calibrator handy for use. e a <br /> 3. Tum on the pump and adjust the flow <br /> by holding the"SET"button and pressing the up(to increase flow)or <br /> the down arrow(to decrease flow)button. <br /> 4. Measure the flow with the rotometer or calibrator. <br /> 5. Continue to adjust until a satisfactory flow is obtained. <br /> 6. Releasing the"SET"button saves the flow rate to memory and the <br /> next time the pump is turned on it will resume this flow. <br /> LED Indications <br /> The green LED will blink for each pressing of the arrows in Step 3 above. <br /> The orange LED will light is the flow is higher than the pump is capable of <br /> maintaining. <br /> If the red LED comes on,stop and recharge the batteries. <br /> g 9 <br />