Laserfiche WebLink
2.0 HAZARD IDENTIFICATION AND CONTROL <br /> Precautions must be taken to prevent injuries and exposures to the following potential hazards <br /> I <br /> TABLE 2-1 <br /> POTENTIAL HAZARDS AND CONTROL <br /> Potential Hazard Control <br /> Exposure to 1 Stand up-wind of petroleum products whenever possible <br /> Petroleum Products, 2 Avoid contact or mimnuze contact time with petroleum products <br /> Chlorinated or 3 Avoid walking through discolored areas, puddles, leaning on drums, or <br /> Hydrocarbon-based contacting anything that is likely to be contaminated <br /> Solvents 4 Do not eat, drink, or smoke in the contaminated areas <br /> 5 Wear gloves when in contact with contaminated surfaces <br /> 6 Safety glasses must be worn at a minimum <br /> 7 Splash goggles must be worn when working with large volumes of <br /> liquids <br /> 8 >99 ppm orgame vapors in breathing zone requires upgrade to Modified <br /> Level D <br /> 9 2500 ppm organic vapors in breathing zone requires stopping work until <br /> additional precautions are taken <br /> 10 If unknown materials are encountered, call the CHSO <br /> Vehicular Traffic I Wear traffic safety vest or equivalent when vehicle hazard exists <br /> 2 Use cones, flags, barricades, and caution tape to define work area <br /> 3 Use vehicle to block work area <br /> 4 Use the buddy system <br /> 5 Engage police detail for high-traffic situations <br /> Inclement Weather 1 Stop outdoor work during electrical storms and other extreme weather <br /> conditions such as rain or hail <br /> 2 Take cover indoors or in vehicle <br /> 3 Listen to local forecasts for warnings about specific weather hazards <br /> such as tornadoes, hurricanes and flash floods <br /> Noise I Wear hearing protection when equipment such as a drill rig, <br /> jackhammer, cut saw, air compressor, blower or other heavy equipment <br /> is operating on the site <br /> 2 Wear hearing protection whenever you need to raise your voice above <br /> normal conversational speech due to a loud noise source, this much noise <br /> indicates the need for protection <br /> Electric Shock 1 Locate and mark all underground or overhead utilities before drilling or <br /> excavating <br /> 20-foot minimum clearance from power lines required, <br /> 10-foot rmiumum clearance from sluelded power Innes <br /> 2 Use ground-fault circuit interrupters as required <br /> 3 Perform lockoutltagout procedures (Appendix 3) <br /> 4 Use three-pronged plugs and extension cords <br /> 5 Determine if cathodic protection is installed and turn off if it presents a <br /> hazard <br /> 8 <br />