Laserfiche WebLink
McCormick and Baxter Memorandum Page 4 <br /> Disposal Profile Sampling <br /> 714-MFP: Sample of aluminum sheet metal collected from the Front <br /> Pile. The metal appeared to be very clean. <br /> SEPTEMBER 1, SAMPLING EVENT <br /> On September 1, 1994, TAT collected four samples from the Command <br /> Post to further characterize site debris. The results from this <br /> sampling event are presented in Table 4. <br /> TABLE 4 <br /> Analytical Results from September 1, 1994 <br /> Command Post Sampling <br /> McCormick and Baxter, Stockton, CA <br /> Total PCP STLC PCP <br /> (mg/kg) (P 9/1) <br /> SAMPLE ID [CA TTLC limit = 17.0 [CA STLC limit = 1.7 <br /> mg/kg] mg/l] <br /> Office 1 18 ND (1,500) <br /> Office 2 13 ND (500) <br /> Office 3 ND (<5) Did not analyze <br /> Office 4 ND (<5) Did not analyze <br /> ND = Non-Detect (Reporting Limit) <br /> Description of September 1, 1994 Samples <br /> All samples were gathered by using a hand drill with a one inch <br /> wood drill bit. The wood chips from the drilling operation were <br /> collected in paint buckets then transferred into 8 oz. sample jars. <br /> All sampling equipment was dedicated. Verbal results for the STLC <br /> were received from the laboratory on September 29, 1994. <br /> Office 1: This sample was collected from the northwest corner of <br /> the command post approximately 1.5 feet east of the building corner <br /> and 1 foot below the roof. The sample appeared to have been <br /> untreated redwood siding. <br />