COMPLIANCE INFO_2010-2012 - Laserfiche WebLink

Home Browse Search

Proper installation of each tank sump is essential: • Read, understand and follow these instructions. • To ensure the safety of all the individuals involved in ° Barricade the work area. the installation. • To prevent sump damage and/or failure, which could ° Review and prepare complete the installation lead to product loss and environmental contamination. checklist as the installation progresses. • To validate the sump warranty. If you have questions on other sump installation details, call CSI Technical Support. To prevent fire or explosion hazard,CSI recommends air driven tools whenever possible.DO NOT use power Do not enter tank or sumps unless following OSHA tools where flammable vapors or liquids exist.Also,when electric hand tools are used, be aware of potential shock guidelines for confined space entry. Failure to hazards.Wear protective clothing and eye protection. follow OSHA guidelines could result in death or serious injury. e • t IL A • • r In freezing conditions,protect collar and sump from water accumulation. Freezing water may cause damage. ASPHYXIATION FIRE EXPLOSION • Visually inspect the sump components for shipping damage. If damage is found, contact CSI Field Service. • • - � • Wear gloves. • Do not roll, drop, or bounce. • Sumps must be installed according to these • Set on smooth surface. instructions and NFPA 30, 30A, 31,OSHA and all . The sump must be secured to prevent damage from applicable Federal, State, Local, or Provincial, high winds. Proper precautions should be taken to construction, safety and environmental codes and protect adhesive channels. regulations. • Any variances or deviations which are in direct • conflict with these published installation instructions must be approved in writing prior to the installation by Containment Solutions Tank Technical Support. Sump must be isolated from direct traffic loading. • The presence of any Containment Solutions representative at the job site does not relieve the Dry fit all sump components. contractor of responsibility to follow these installation - Determine any length changes required to insure instructions. the minimum required clearance between the sump top and concrete. e - Confirm enclosure top is level. • If required, trim sump body extension using a carbide • These instructions must be followed. tipped blade or a masonry blade (see Figure B-1). • The Installation Checklist must be properly completed • Field cuts must be within ±'/4"of square. Gaps and signed by the tank owner's representative and between two joints greater than /4' must be covered the installing contractor. with a maximum 1/2"wide tape. • The Sump Installation Checklist, these instructions, • Remove any rocks, and/or debris from channel. and any correspondence related to the sump • Sand and clean mating surfaces until white in color. installation must be retained by the tank owner and - Adhesive Joints-Sand all the surfaces that will provided to CSI to validate any future warranty claim. contact the adhesive, then wipe free of dust with a • The sump must be continuously monitored for piping clean cloth. leaks using an electronic leak monitoring sensor. - Layup Joints- Sand a minimum of 4"onto each • The sump must be tested using one of the part where the layup will be applied, then wipe free procedures described in this manual. of dust with a clean cloth. 2