Laserfiche WebLink
D. Alternate construction for new underground storage tanks containing motor vehicles fuel [Section 25333. <br />(1) Monitoring and response plan [Section 26347. <br />® (2) Underground storage tank composed of.... <br />(a) Fiberglass reinforced plastic. <br />® (b) Cathodically protected steel. <br />(c) Steel clad with fiberglass reinforced plastic. <br />(d) Other material that complies with section 2631 and 2632. <br />(3) Floor of leak interception and detection system constructed on a firm base and sloped to a <br />collection sump (use of membrane liners comply with section 2631 (d) (6) requirements.) <br />(b) Access casings instailed in the collection sump of the secondary containment system with <br />backfill in the interstitial space. The access casing shall meet all of the following: <br />Designed and installed to allow the liquid to flow into the casing. <br />Sized to allow removal of collected liquid and able to withstand all anticipated applied <br />stresses. <br />Constructed of material that will not be structurally weakened. <br />Screened along entire vertical zone of permeable material. <br />Capable of preventing leakage of any hazardous substance from the casing. <br />Extend to the ground surface and covered with a locked waterproof cap. <br />Capable of meeting S.J. Co. PHS-EHD Wait Standards. <br />Leak interception and detection system shall prevent the leaked hazardous substance from <br />entering ground water. <br />14. INTERSTITIAL SPACE MONITORING <br />A. Visual monitoring [Section 2632 (c) (1)I <br />(a) Exterior surface and floor beneath tank monitored by direct viewing <br />VL4,' (b) Daily visual inspections <br />N- (c) Liquid level in tank to be recorded at time of inspection <br />BZA (d) If liquid observed around or beneath primary tank, owner will determine if an unauthorized release <br />has occurred. <br />B. Mechanical or electronic monitoring [Section 2632 (c),(2)] <br />(a) Continuous monitoring system connected to an audible and visual alarm system. <br />Monitoring equipment to be installed <br />Manufacturer: <br />Model Number • T— J ® �® <br />Sensor Type: WA Vapor Liquid M/ABoth. <br />Sensor/Panel specifications. <br />j ' Location(s) f,QQr sensors: . A <br />Tank: ULA K Piping: JU'V i <br />Dispenser: sone <br />C. Monitoring and response plan submitted [Section 2532 (d) (1) & (2)I. <br />15. Any special accessories, fittings, coatings, or linings not inherent within the initial design of the 1° tank or <br />double-wall UST. [Section 2631 (b)] <br />A. Approved by a nationally recognized independent testing organization. <br />B. Demonstration of integrity with the primary and/or secondary containment. <br />C <br />